So i replaced my wheel bearings and found that my spindle is stripped so the spindle nuts wont tighten my question is should i try and re thread this or get a new one also all the shops in my town cannot find a spindle does anyone know where i can get one?

 

Also its 4x4 manual lockers and a dana 44

 

your not going to find new, you can hit up the salvage yards,
this is one of the only sites I know that sells them.
http://www.woodfins.com/ford/f150-pickup/1994/spindles/

 

Jeffs bronco graveyard has them.

 

Ok thanks. Would any of you recommend getting it re threaded (no yards where i live

 

I would recomend a new spindle due to the fact that a failure could be catastrophic there by endangering to lives of yourself, passengers and people in cars nearby should a total failure occur.