I have an 88 F150 4x4 4.9l 4 speed. I am getting parts together to swap both axles. So far I have a HP Dana 44 and 9" out of a 77 F150, along with the radius arms, panhard bar, and 4" lift coil springs. I plan to get some 2" urethane coil spacers(leveling kit) to provide 6" total front lift, then get some 6" springs for the rear, along with a 3" body lift. I want to run 38x12.5 swamper TSL's. What radius arm drop brackets should I use? What about the steering, how should I set it up? Will 6" suspension + 3" body be enough to run 38's?

Oh yeah, the axles have 3.50 gears and the 9" has a trac-loc.

Thanks in advance,
Joe

 

Look up rough country they sell the drop kits you need. You may clear 38s okay. But it may rub

 

my buddies truck with a 6" lift cleared 39's. add the body lift and you will be golden for 38's

 

mine is 6 and 3 lift with 38s no rubbing little bit of bumper trim

 

Thanks for the responses. What about some 39.5 swamper TSL's? Think they would fit?

 

not sure if they sell/make em for these but if possible a 1 inch coil spacer would probably make them clear no problem