'95 5.0 EFI. Getting her back together and I pulled a bonehead stunt. When it was removed, we had put the intake bolts in the correct holes so we wouldn't get them mixed up. I was cleaning the old gasket material off today, turned it over too far and the bolts fell out.

There are two very long ones that are double ended and not sure which position they go in. We can figure it out by trial and error in the morning when bolting it down, but knowing where they go would help

 

the stud-type ones go on the driver's side towards the back. I'm not positive what holes exactly, but I know it's for the coil to mount to. It should be pretty obvious if you picture the coil mounted.

 

Using the image below, the intake studs go in #2 and #10.

 

Thanks guys! My buddy took it off, so I wasn't sure of the location. After reading about mounting the coil, it became embarrassingly clear where they went. We really need a slaps forehead smiley