I purchased some hid headlights for my 94, they are with new housings aswell and they dont have the stock adjuster on the bottom, they have the same on the top with the two screws but the bottom is just the same as the top and with one of those c clip type things. its an extended one about 4 inches long but i have no clue how to get it in, it seems there is no way.. unless i take the front clip off, but im sure im just missing something simple.
also it has three leds on the side that i can use with headlights or turn signals. I want to wire them to my turn signals, which wires should i splice them into?
thanks, any advice or ideas at all are appreciated
this is what they look like up front

 

You'll have to swap out the bottom adjusters from your old lights. Grab 2 small flat head screwdrivers and some channel locks. put the screwdrivers under the tabs on the adjusters to lift them up and at the same time twist the piece with the channel locks. it should pop out. Then put the old adjusters in the new lights. Your probably gonna have to cut out the piece on the bezel that the corner bolted to before the new light fits in. I did. Good luck and if you need anything else let me know. I got these same lights.

 

is there no other way to do it other then putting the stock ones back on cause my stock ones were broken and ford wants $35 a piece for the stock ones, i could just take the front clip off i guess and do it that way. and just use the top two for alignment and roughly align the bottom one when the front clip is off.. oh and did you get the headlight bezels on? just cause they dont have the two bolt holes on the side of these headlights. did you just cut that part of the bezel off and just use the two top and two bottom mounting screws? thanks

 

You need all three of those adjusters i think. Where is it broken at? I'm thinking if you can salvage just the part that screws in you can use that. The ends on the new lights are rounded and the stock adjusters are flat on the top and bottom, that's why the ones on the new lights won't work.

On the bezel, you will need to cut out part of it that is keeping the new light from setting flush. Yes, it's the part for the corners. I left the two bolt holes there, just in case I ever wanted to put my old lights back in. Try fitting the light in bezel with the turn signals already mounted. You will be able to tell what to cut out. I used a dremel to shave what I didn't need off.