Headers?
Member
Joined: Feb 2011
Posts: 96
Likes: 0
Ordered some flowtech shorties for my 95 5.0 and Saturday they're going on! I ordered them from summit service and price are great. But also be sure to get some DEI spark plug protectors!! About twenty dollars for 8 and it was 35 for the exact thing except it was a pack of two. Good luck y'all!
Senior Member
Joined: Jun 2010
Posts: 605
Likes: 0
From: Camden, Alabama
Questions
Got a couple questions bout your headers. First, where did you buy them from if I may ask. Second, what particular model are they? Want to look into finding some for my truck that wont require a month to put on.
You Talking to ME!
Joined: Feb 2010
Posts: 146
Likes: 0
From: Norman, Oklahoma
Semper..Mine will arrive Monday..heres what I bought..from Summit on ebay...
http://www.summitracing.com/parts/BIG-12502FLT/
FlowTech Headers 12502FLT
$145.95 and $11.95 Shipping to Oklahoma
- Bolts/Studs IncludedYes
- Collector Attachment3-bolt flange
- Collector Diameter2.500 in.
- Flange StyleStandard
- Flange Thickness (in)5/16 in.
- Footnote LegendBIG
- Gaskets IncludedYes
- Header FinishPainted
- Header MaterialSteel
- Header StyleFull-length
- Motor Mounts IncludedNo
- Primary Tube Diameter (in)1 1/2 in.
- Primary Tube Gauge18-gauge
- QuantitySold as a pair.
- Reducers IncludedYes
- Transmission Mount IncludedNo
- TunedNo
- Y-Pipe IncludedNo
You Talking to ME!
Joined: Feb 2010
Posts: 146
Likes: 0
From: Norman, Oklahoma
I have shortys and I have a leak. Driver's side, flange. One bolt was tightened down the other was improperly tightened down. PITA to get to is right beside the frame, above the starter, below the heater. It is now rusted in there will have to be cut and replaces to be properly tightened. Drivers side is fine. Its that pass side that has no room.
Get a set of these..never have to worry again..I use them on New Challenger 70 Charger R/T and soon 92 F-150
http://www.summitracing.com/parts/STG-8913/
Junior Member
Joined: Feb 2010
Posts: 28
Likes: 0
same here and no leaks!!! best part is i got em new on craigs list for 50 bucks. but one thing i had to do to em is cut off the flange that you ust to connect the pipe to the header because is was rubbing aginst the font drive shaft. so i welded the pipe directlly to the collector and i havent had any problems since