Driveshaft Center Support Bearing - How do I get this thing off?
02-03-2009, 10:47 AM
#11
Junior Member
Thread Starter
Join Date: Jan 2009
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
I punted and didn't replace it. I needed to drive the truck to work on Monday so I just did the new ujoints on the driveshaft. The center support bearing will have to wait until summer when I can ride the KTM to work and leave the truck up on jack stands if I need to.
06-19-2010, 05:59 PM
#12
Junior Member
Join Date: Jun 2010
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Just went through this on my dads truck. 10 minute job (getting old bearing off 
) with a grinder and cut off wheel. Have to go through a couple of layers of bearings to get down to the race. Also, be sure to make diagonal cuts as to not cut into the ds dust shield.
) with a grinder and cut off wheel. Have to go through a couple of layers of bearings to get down to the race. Also, be sure to make diagonal cuts as to not cut into the ds dust shield.