Topic Sponsor
1987 - 1996 F150 Still running strong! Talk about your 8th and 9th generation Ford F150 trucks.

Charging problems

Thread Tools
 
Search this Thread
 
Old Feb 5, 2010 | 04:19 PM
  #11  
ymeski56's Avatar
Senior Member
Supporting Member

 
Joined: Jul 2008
Posts: 58,557
Likes: 1,165
From: Long Beach Calimexifornia
Default

Originally Posted by rockzo6
Ok I finally got to take readings with my multimeter. With the truck turned off it is showing 12.1v at the battery. With the truck running it shows 14.3v, that is with no extra load and with everything turned on still 14.3. With the battery showing 12.1v the truck will not turn over or should I say it turns over too slow to start. The cables from the battery are good, I replaced the negative cable 2 years ago. I am leaning towards the cable going to the starter or the starter itself. What do you guys think. One other thing I measured ac current at the battery with the truck running, I got flashing reading of 0.0 and 8.9 could this have something to do with it? I think it does but can't remember what.

Thanks for reading the paragraph and the help
Greg
Anything below 12V is discharge. I hope your not showing AC current, cause it's a DC system. Take the battery in and have it "Load tested". You should have more than 12.1 at rest there also. You may have a dead cell. This doesn't explain the heater switch implication, but will remove the BAT from the list of possible troublemakers.

Last edited by ymeski56; Feb 5, 2010 at 04:23 PM.
Reply
Old Feb 5, 2010 | 04:45 PM
  #12  
rockzo6's Avatar
Thread Starter
Junior Member
 
Joined: Oct 2008
Posts: 5
Likes: 0
From: FT Drum, NY
Default

I know it's a dc system, but on another forum I visit the electrical expert always says check ac at the battery. I can't remeber why, will go back and check. I think it has to do with a short. I will check the wires to the starter. I am thinking that or the starter itself. I will let you know what I find tomorrow.

Thanks,
Greg
Reply
Old Feb 5, 2010 | 05:48 PM
  #13  
J.A.C's Avatar
Senior Member
 
Joined: Dec 2009
Posts: 327
Likes: 3
From: Fresno California
Default

the only way u going to get AC in electrical system its if one of the diodes in alternator goes bad but that can damage electrical components or just dont work cause they r make to work on DC.
Reply
Old Feb 5, 2010 | 05:54 PM
  #14  
ymeski56's Avatar
Senior Member
Supporting Member

 
Joined: Jul 2008
Posts: 58,557
Likes: 1,165
From: Long Beach Calimexifornia
Default

Originally Posted by rockzo6
I know it's a dc system, but on another forum I visit the electrical expert always says check ac at the battery. I can't remeber why, will go back and check. I think it has to do with a short. I will check the wires to the starter. I am thinking that or the starter itself. I will let you know what I find tomorrow.

Thanks,
Greg
A BAT w/ a dead cell will discharge, especially when a starter load is put upon it. Hence "Load testing" the BAT, which is different than testing at rest.
Reply




All times are GMT -4. The time now is 05:45 PM.