alright so i replaced my brake calipers on my 93 f150 4x4 because the were bad but im still not getting good brake pressure....ive tried everything but still the peddle hits the floor...does anyone have a solution to this...i loosened up the brake line pumped the brakes and nothen....i did that about 6 times....so i started the truck up and did the same and nothen....i took the top off the brake fluid and did all that too and still nothen i need help please anyone anything helps...help me get my ford back on the road...

i appreciate everyones help...thanks

 

your master cylinder may be bad....

 

which side did u start with and how good of fluid is coming out?

 

i started with the driver side and its comen out good...

 

your supposed to start with the furthest side away from the master... try bleeding the right side real good then the driver side...2 thing could have happened... either theres alot of air now in the lines or wen bleeding u pushed to far down on the pedal blowing the seals out... when i bleeed brakes on fords i put a block of wood behind the pedal

 

alright ill go try and do that in this ****ty washington rain lol...wat would it take to replace the seals if that had happened...

 

new master cylinder... also try bleeding the rears if you can... no how u bleeding them with 2 peole or the bleeder kit?

 

hopefully its not that then...but alright ill see if i can do the rear and im doin it with 2 people...

 

okay lemme know how you make out

 

okay guys, this is getting a little to out of hand... im laughing so hard right now, that im crying hahaha