Bench to Bucket seat question
#1
Senior Member
Thread Starter
Bench to Bucket seat question
I am planning on swapping my Bench seat out of my 95 for Captains seats and a console. How much extra drilling will I need to do to get the buckets to fit? Thanks
#2
Senior Member
never done this my self but reading from other topics,
ethier half the wholes or all of them i think.
but you should search up on google or look on old posts.
might be able to find quicker
ethier half the wholes or all of them i think.
but you should search up on google or look on old posts.
might be able to find quicker
#4
Senior Member
You will lose the slide adjustment, unless you make one yourself and I believe you will only have to drill 4 extra holes, for the inside of the seats.
I was reading up on this before and just never got around to it.
I was reading up on this before and just never got around to it.
#5
Senior Member
i used one of the stock bolt holes as a guide and drilled three new ones. the seat of to far into the middle but doesnt effect comfort. not for me anyways.
#7
Senior Member
idk if puting them elsewhere would be better, but the back left peice has caved in the floor a little and i only weigh 160. when i go to move them im gonna put a thicker peice of steel plate there.
Trending Topics
#8
Senior Member
Thread Starter
Yeah, I am getting the tracks for the seats with them so it will slide, I will probably just redo the whole interior at that time. I will lay thicker steel and angle iron down most likely. I will measure where the seats are placed on my grandpas truck, and will mount the buckets in my truck where they are placed in my grandpas truck. Since mine is a manual tranny so I want the seats to be in the right position