7th Generation Front end bolt to 8th generation truck?
#1
7th Generation Front end bolt to 8th generation truck?
I was curious as to if anyone here had swapped the front end from a 1980-86 F150 to the 87-92?
I like the way the older one looks a lot better and am interested in doing the swap if its as easy as unbolting and re-bolting
I like the way the older one looks a lot better and am interested in doing the swap if its as easy as unbolting and re-bolting
#3
Super Moderator
It works, there's a little finessing needed to the core support mounting though. You will need the entire clip though, hood, fenders, core support, and inner fenders. I don't think the 87-91 bumper will look right either but I'm not positive on that
#4
Jordan
I believe you'll even need the wiper cowl as well.
Also keep in mind that the bullnose trucks (80-86) had different wheel wells than the next two generations...
It might look funny unless you get a new truck bed, or cut and paste some fenders.
I hate to link to another forum, but here is the exact reverse operation done on a Bronco: http://fullsizebronco.com/forum/showthread.php?t=74355
Also keep in mind that the bullnose trucks (80-86) had different wheel wells than the next two generations...
It might look funny unless you get a new truck bed, or cut and paste some fenders.
I hate to link to another forum, but here is the exact reverse operation done on a Bronco: http://fullsizebronco.com/forum/showthread.php?t=74355
Last edited by mr7confused; 05-22-2013 at 01:46 PM.