1994 f250 interior
#1
vertical pin buster
Thread Starter
1994 f250 interior
I just bought a 1994 f250 poweretoke. Its a supercab. My question is. It has the jumper seats. With a soild bench up front. How much trouble will it be to switch the jumpers to a bench seat. Ill probably switch the front to. Any info is appreciated
#2
Its an easy job to switch out all the interior, you will need a large Torx set, the front bench seat is held down only with 4 Torx bolts:
You can get a set of bucket seats out of any similar truck, and the same bolt holes are used to secure the frame, on which the bucket seats are bolted.
should take about an hour.
for the rear you can buy a small bench from a breakers or similar, and bolt it in
You can get a set of bucket seats out of any similar truck, and the same bolt holes are used to secure the frame, on which the bucket seats are bolted.
should take about an hour.
for the rear you can buy a small bench from a breakers or similar, and bolt it in
Last edited by MarcusAOB; 12-10-2016 at 03:18 PM. Reason: sp
#4
Senior Member
See my post on this thread regarding the seat pan assembly you MUST find unless you want to drill 6 more holes in the floor of your truck. A bench seat o buckets or to a 40/20/40 seat is a total P.I.T.A. without this seat pan assembly.
https://www.f150forum.com/f92/newer-seats-93-a-304419/
https://www.f150forum.com/f92/newer-seats-93-a-304419/
The following users liked this post:
Rebel Patriot (01-14-2017)