95SWB

I'm pulling a m5r2 out of my truck to install zf5-42 and can't find a driveshaft long enough. Rough measurement comes too 65 3/4 and current one is 58 5/8. These measurements are from transmission yoke to flange on rearend. I was told that the driveshaft from a reg cab long bed 4.9 e4od with one piece driveshaft will work but can't find proper measurements or junkyard one that isn't bent.

Just call me Sean

iTrader: (1)

Have one made.

95SWB

Next question, is it safe to run fixed yokes on both ends of one piece driveshift without carrier bearing split shaft?

Just call me Sean

iTrader: (1)

It needs a slip section.

95SWB

Does anyone have a standard cab shortbed with zf tranny?

Just call me Sean

iTrader: (1)

You don't need a center support bearing, just a slip section.

95SWB

So I can take driveshaft that was on it and just shortened it?

Just call me Sean

iTrader: (1)

If you're having one made take what you have and they will use what they can.

95SWB

I only have the front portion of the split shaft