Installing Ford OEM HID's....HELP!!!
#111
I hate to resurrect this thread but I'm also having this issue where my HID headlights won't work on my '10 XLT. I've gone through two harnesses already. I have everything wired up correctly. Grounds are at stock locations on back of radiator support. I checked the bulbs and fuses, they looked good. Is there anyway to check the ballasts? I suspect they are the culprit since everything else looks fine.
#112
Senior Member
Thread Starter
I hate to resurrect this thread but I'm also having this issue where my HID headlights won't work on my '10 XLT. I've gone through two harnesses already. I have everything wired up correctly. Grounds are at stock locations on back of radiator support. I checked the bulbs and fuses, they looked good. Is there anyway to check the ballasts? I suspect they are the culprit since everything else looks fine.
#113
Pull out the connector at the Moritomo controller...I'd look for corrosion on either side of the connectors and spray it with electronics / contact cleaner really well to see if that helps. It's almost impossible both of your ballasts are bad, if you have only 1 bad ballast that headlamp won't be working and the other one will be fine. Your issue must be again bad controller / flaky connection into or out of controller or fuse if neither of your headlamps are working.