1993 f150 check eng light
#1
Member
Thread Starter
Join Date: Apr 2011
Location: oklahoma
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
1993 f150 check eng light
Hello everyone...
Thanks for viewing this...
I just did a major repair on my truck i just got....
Its a 1993 f150 with the 5.0 v8...
I got it for 500$ wouldn't start but had a perfect body and a perfect inside
It had 120+ on the compression test extp cylinder 8 which had only 2psi...
After tearing it down i found a valve with a very small chip in it causing the system not to seal...
I replaced it and installed all new upper gaskets from the heads up...
I haven't had no problems{No smoke or anything like that}...
It starts fine but I have a check engine light on-What can i do to find out what this code is???autozone doesn't have a code reader for it soo what do i do?
when i was working on the exhaust system I busted a metal pipe that runs from the 1st cat up into the engine area )Seams to be some kinda recycle system or smog control(Any idea what this is???
I had to remove the thermostat bc it was sticking-Will it hurt the engine not running the thermostat??
I also busted the Coolant Temperature Sensor -Ill be replacing this tomorrow!!!But could this throw a code???
Can Any one give me some answers to these questions?
Thanks for viewing this...
I just did a major repair on my truck i just got....
Its a 1993 f150 with the 5.0 v8...
I got it for 500$ wouldn't start but had a perfect body and a perfect inside
It had 120+ on the compression test extp cylinder 8 which had only 2psi...
After tearing it down i found a valve with a very small chip in it causing the system not to seal...
I replaced it and installed all new upper gaskets from the heads up...
I haven't had no problems{No smoke or anything like that}...
It starts fine but I have a check engine light on-What can i do to find out what this code is???autozone doesn't have a code reader for it soo what do i do?
when i was working on the exhaust system I busted a metal pipe that runs from the 1st cat up into the engine area )Seams to be some kinda recycle system or smog control(Any idea what this is???
I had to remove the thermostat bc it was sticking-Will it hurt the engine not running the thermostat??
I also busted the Coolant Temperature Sensor -Ill be replacing this tomorrow!!!But could this throw a code???
Can Any one give me some answers to these questions?
#2
Kill em all
The pipe is part of the EGR, you gas mileage will go to crap with out he thermostat, not sure if the temp sensor will throw a code, I don't think so. Get the haynes or chiltons for the vehicle and it will explain how to get the codes.
#4
Member
Thread Starter
Join Date: Apr 2011
Location: oklahoma
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
ok Thanks guys....I ran the truck down the high way today and at 80mph you couldn't feel and thing it was soo smooth LOVE IT....
I fixed the coolant sending unit today 14.00$ at autozone.
Ill get the egr tube fixed next!!!
Thanks soo much guys.
I fixed the coolant sending unit today 14.00$ at autozone.
Ill get the egr tube fixed next!!!
Thanks soo much guys.
#5
Member
Thread Starter
Join Date: Apr 2011
Location: oklahoma
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
Well got the check engine light off....Not sure what I did maybe something was just stuck or upset from setting so long....
ok last question what are some ways to check for a exhaust manifold leak???
Iv got a popping or clicking sound on cly8 or soo.....Iv re-torqued and adjusted the manifold and its got better and its almost gone when its warmed up (Some times is gone) buts its driving me up the wall....
I do not believe it is a valve tick...
Thanks
ok last question what are some ways to check for a exhaust manifold leak???
Iv got a popping or clicking sound on cly8 or soo.....Iv re-torqued and adjusted the manifold and its got better and its almost gone when its warmed up (Some times is gone) buts its driving me up the wall....
I do not believe it is a valve tick...
Thanks