Level kit and unmodified crash bars, pictures and build details
#31
Here ya go... Just got her done today. The evolution is below.. Stock, leveling kit.. and the aftermath of the wheels and tires.
Attachment 452705
Attachment 452707
Attachment 452708
Attachment 452706
Attachment 452705
Attachment 452707
Attachment 452708
Attachment 452706
I was debating whether to add another inch block in the rear or not, now I am debating either 2 inches or 3 inches total.
#32
I think 34's would scrub on the bar without some slight mods to the bar..
The following 4 users liked this post by haynraptor:
AndMan (10-22-2016),
joeincharlotte (04-01-2017),
ShiverMeTimbers (10-25-2016),
tibis3383 (02-21-2018)
#34
I moved them until they were "inside" the bumper.. Meaning I'd hit my bumper before the bar. The bar moved easily.. I would recommend having an extra set of hands but it could be done by yourself. Unfortunately I did not take measurements.
I think 34's would scrub on the bar without some slight mods to the bar..
I think 34's would scrub on the bar without some slight mods to the bar..
#35
about to get my truck leveled and have some new wheels put on and was wondering if i could get away with a +1 offset with 275/70/18 ko2s with a 2.5" level in the front without rubbing. I would prefer to not remove the crash bars if possible.
Thanks.
Thanks.
#36
Senior Member
I have 285/65/20 (34.6") Nitto Terra Grappler G2 on stock 20's, with 1.5" level. I have no rubbing issues at all.
#37
Well I went with 275/70/18 K02's to be mounted on Mayhem Warrior 18x9 with -12 offset. Discount Tire matched the best prices I could find on both. Will post pictures once those are done along with the 2.5 inch level and extra inch blocked added to the rear.
Hoping it all turns out well, I am a bit nervous. Would have liked to go bigger, especially since the trucks with the level and 35's look so good, but didnt want to modify my crash bars. Once I have to replace these in a few years I will add a lift and 35's.
Hoping it all turns out well, I am a bit nervous. Would have liked to go bigger, especially since the trucks with the level and 35's look so good, but didnt want to modify my crash bars. Once I have to replace these in a few years I will add a lift and 35's.
#38
Super Moderator
Stock rims ,No rubbing , plenty of room
The following 2 users liked this post by Phil48315:
chiefapple (10-27-2016),
joeincharlotte (10-25-2016)
#39
Senior Member
Sooooooooooo,
Any advice for a guy planning on a 0 offset wheel not wanting to mess with the crash bars? I was thinking probably 33"ish would be safest, maybe a 295/70 (~33x~12) with a 17x9 0mm offset wheel.
Also, sub'd
Any advice for a guy planning on a 0 offset wheel not wanting to mess with the crash bars? I was thinking probably 33"ish would be safest, maybe a 295/70 (~33x~12) with a 17x9 0mm offset wheel.
Also, sub'd
#40
Do you plan on lifting or leveling it?