Ford F150 Forum - Community of Ford Truck Fans - Search Results



Showing results 1 to 25 of 151
Search took 0.11 seconds.
Search: Posts Made By: Pmoon
Forum: 2004 - 2008 Ford F150 04-02-2015, 01:45 PM
Replies: 12
Views: 1,061
Posted By Pmoon
Get an actual reading of the oil pressure. Could...

Get an actual reading of the oil pressure. Could be worn bearings causing your oil pressure to be too low to operate the vvt system. Voice of experience, when it was rebuilt had the livernois lockout...
Forum: 2004 - 2008 Ford F150 04-02-2015, 01:34 PM
Replies: 8
Views: 679
Posted By Pmoon
When I was under the truck installing the new...

When I was under the truck installing the new driveshaft i noticed the whole bottom of the truck was sprayed with transfer case oil , so I went to my local oil change shop and got an oil change and...
Forum: 2004 - 2008 Ford F150 03-31-2015, 02:05 PM
Replies: 8
Views: 679
Posted By Pmoon
Thanks guys, just got the driveshaft a day early...

Thanks guys, just got the driveshaft a day early so should be installed this afternoon. Appreciate the responses.
Forum: 2004 - 2008 Ford F150 03-30-2015, 11:34 PM
Replies: 8
Views: 679
Posted By Pmoon
front wheel drive f150

Ok, so I knew my center support bearing on my drive shaft was about to blow up when I left the house tonight but I drove the 40 miles to my son's baseball game and sure enough it self destructed as I...
Forum: 2004 - 2008 Ford F150 03-30-2015, 09:01 AM
Replies: 53
Views: 7,640
Posted By Pmoon
I Just had my engine rebuilt and added your...

I
Just had my engine rebuilt and added your lock-out system, what weight oil should/can I run now?
Forum: 2004 - 2008 Ford F150 03-14-2015, 10:49 AM
Replies: 418
Views: 275,718
Posted By Pmoon
Phasers

Ok , so in July I had the phaser job done at the steelership and now in March it's making the diesel sound again so I take it back and they say its the vct's to wich I say bs cause they are less than...
Forum: 2004 - 2008 Ford F150 02-10-2015, 10:50 AM
Replies: 3
Views: 471
Posted By Pmoon
Had problems similar to these and it turned out...

Had problems similar to these and it turned out to be the aftermarket remote starter was poorly installed and had loose wiring.
Forum: 2004 - 2008 Ford F150 01-26-2015, 10:50 PM
Replies: 46
Views: 82,300
Posted By Pmoon
Try this test, put the truck in drive, with your...

Try this test, put the truck in drive, with your foot on the brake give it enough gas to raise the rpms by about 500 then let off the gas. If it sounds like it's running with no oil in it you need a...
Forum: 2004 - 2008 Ford F150 10-30-2014, 10:08 PM
Replies: 33
Views: 5,514
Posted By Pmoon
Short flexible antena to replace the bent stock...

Short flexible antena to replace the bent stock one, $15 bucks
Forum: 2004 - 2008 Ford F150 10-09-2014, 11:46 PM
Replies: 6
Views: 681
Posted By Pmoon
It's been raining? Have you ever replaced the...

It's been raining? Have you ever replaced the fpcm?
Forum: 2004 - 2008 Ford F150 10-09-2014, 11:39 PM
Replies: 1
Views: 955
Posted By Pmoon
p2006, intake manifold runner

I have a p2006 code on my 2005 5.4 so I felt behind the intake and it seems that the rod has come detached from the runner valve. Is there a way to fix it without taking the intake manifold off?
Forum: 2004 - 2008 Ford F150 09-10-2014, 09:04 PM
Replies: 4
Views: 1,356
Posted By Pmoon
You will know right awaywhen you take it off the...

You will know right awaywhen you take it off the frame, lots of corrosion on the back. Really, it's an easy and relatively cheap fix and if you haven't done it yet, even if it's not the cause of your...
Forum: 2004 - 2008 Ford F150 09-07-2014, 10:27 AM
Replies: 3,409
Views: 1,555,196
Posted By Pmoon
Cats

Could the phaser problem have plugged up one of my cats? Had the phasers done but still doesnt have the power it should have and has a lag in accelleration, also has a code for plugged cat (bank one)...
Forum: 2004 - 2008 Ford F150 06-25-2014, 01:02 AM
Replies: 19
Views: 1,463
Posted By Pmoon
I was going to suggest the old banging on the...

I was going to suggest the old banging on the starter with a hammer while someone else turns the key but I realized that you would hear the solenoid click (still could try it) Turn the radio and the...
Forum: 2004 - 2008 Ford F150 06-12-2014, 08:49 AM
Replies: 3,409
Views: 1,555,196
Posted By Pmoon
/\ Vct's have been replaced with no effect

/\ Vct's have been replaced with no effect
Forum: 2004 - 2008 Ford F150 06-12-2014, 08:47 AM
Replies: 3,409
Views: 1,555,196
Posted By Pmoon
I dont have a constant deisel sound, it happens...

I dont have a constant deisel sound, it happens when the engine is warm and I come to a stop after running at low rpms, then it really sounds like crap! It doesnt have a lot of power at low rpm...
Forum: 2004 - 2008 Ford F150 06-06-2014, 08:45 AM
Replies: 12
Views: 1,770
Posted By Pmoon
Bump

Bump
Forum: 2004 - 2008 Ford F150 06-03-2014, 12:51 AM
Replies: 12
Views: 1,770
Posted By Pmoon
So where is the cam phase senser located?

So where is the cam phase senser located?
Forum: 2004 - 2008 Ford F150 06-03-2014, 12:49 AM
Replies: 12
Views: 1,770
Posted By Pmoon
When I unplug the vct solenoids

When I unplug the vct solenoids
Forum: 2004 - 2008 Ford F150 06-03-2014, 12:46 AM
Replies: 12
Views: 1,770
Posted By Pmoon
It runs like crap and then goes into fail safe...

It runs like crap and then goes into fail safe mode
Forum: 2004 - 2008 Ford F150 06-02-2014, 08:31 AM
Replies: 12
Views: 1,770
Posted By Pmoon
Bump

Bump
Forum: 2004 - 2008 Ford F150 06-01-2014, 12:15 AM
Replies: 13
Views: 3,161
Posted By Pmoon
Maybe the throttle position sensor?

Maybe the throttle position sensor?
Forum: 2004 - 2008 Ford F150 06-01-2014, 12:11 AM
Replies: 12
Views: 1,770
Posted By Pmoon
Yeah there is no way that this is an exhaust...

Yeah there is no way that this is an exhaust manifold leak, when it starts making the noise if I rev it a couple times it goes back to normal idle.
Forum: 2004 - 2008 Ford F150 05-31-2014, 10:46 PM
Replies: 12
Views: 1,770
Posted By Pmoon
Deisel sound

Well, I just replaced my vct solynoids and I still get a sound under certain circumstances that makes my engine sound like a deisel or like it has no oil pressure. The circumstances that can recreate...
Forum: 2004 - 2008 Ford F150 01-16-2014, 10:17 PM
Replies: 13
Views: 1,623
Posted By Pmoon
Definatly replace the fpdm. That one must be the...

Definatly replace the fpdm. That one must be the original and if its not the problem it soon will be. Was it raining or wet out the day it quit?
Showing results 1 to 25 of 151

 
Forum Jump

All times are GMT -4. The time now is 02:58 PM.


Copyright 2006 - 2017 F150Forum.com We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.