Ford F150 Forum - Community of Ford Truck Fans - Search Results



Showing results 1 to 25 of 29
Search took 0.21 seconds.
Search: Posts Made By: The Ford Kid
Forum: 1997 - 2003 Ford F150 10-29-2011, 09:14 AM
Replies: 7
Views: 2,200
Posted By The Ford Kid
My 99 5.4 did the same thing it was the...

My 99 5.4 did the same thing it was the thermostat the gauge in the dash is just an idiot light
Forum: 1997 - 2003 Ford F150 10-22-2011, 11:43 PM
Replies: 3
Views: 1,040
Posted By The Ford Kid
At work we've had some get stuck so we attack...

At work we've had some get stuck so we attack them with pb blasted put them in the 50 ton press (go big or go home) and the. Switch between those and an air hammer to work them out
Forum: 1997 - 2003 Ford F150 09-25-2011, 09:05 PM
Replies: 48
Views: 3,553
Posted By The Ford Kid
I raced a 2500 with a 6l in high school nationals...

I raced a 2500 with a 6l in high school nationals and he was a second and a half slower then me just launch at the right time and don't have unneeded things in it
Forum: 1997 - 2003 Ford F150 09-02-2011, 10:47 PM
Replies: 36
Views: 3,135
Posted By The Ford Kid
I have a 99 5.4 4x4 4:10 gears and I get like 225...

I have a 99 5.4 4x4 4:10 gears and I get like 225 at 3/4 tank.... I usually don't let it go under that
Forum: 1997 - 2003 Ford F150 09-02-2011, 10:39 AM
Replies: 4
Views: 1,475
Posted By The Ford Kid
To test a MAF sensor take a screwdriver and use...

To test a MAF sensor take a screwdriver and use the but end of it and tap on it when it starts acting up if the problem goes away you found the culprit if not you didn't spend any money
Forum: 1997 - 2003 Ford F150 09-01-2011, 11:06 PM
Replies: 14
Views: 1,100
Posted By The Ford Kid
Wheel bearings? Check them

Wheel bearings? Check them
Forum: 1997 - 2003 Ford F150 09-01-2011, 01:18 AM
Replies: 18
Views: 1,302
Posted By The Ford Kid
Why don't you just apply for lose of title?

Why don't you just apply for lose of title?
Forum: 1997 - 2003 Ford F150 07-22-2011, 12:01 PM
Replies: 1
Views: 384
Posted By The Ford Kid
Vehicle Truck & Auto Parts little ify...

Vehicle Truck & Auto Parts little ify neighborhood but will give you a good deal 313-535-8181
Forum: 1997 - 2003 Ford F150 05-23-2011, 08:46 PM
Replies: 2
Views: 1,007
Posted By The Ford Kid
The sending unit has little finger you could call...

The sending unit has little finger you could call them and that's what reads the level of fuel after a while the fingers wear off
Forum: 1997 - 2003 Ford F150 05-23-2011, 08:42 PM
Replies: 6
Views: 628
Posted By The Ford Kid
The block number? If I'm not mistaken it's under...

The block number? If I'm not mistaken it's under the intake I think not 100 percent sure
Forum: 1997 - 2003 Ford F150 05-21-2011, 05:26 PM
Replies: 16
Views: 5,106
Posted By The Ford Kid
They completely change the look of the front end...

They completely change the look of the front end it makes it look so much cleaner
Forum: 1997 - 2003 Ford F150 05-19-2011, 07:30 PM
Replies: 9
Views: 2,735
Posted By The Ford Kid
Most likely it's the ball joints get in there and...

Most likely it's the ball joints get in there and check for play with a pry bar there very tricky front ends they hide play very well
Forum: 1997 - 2003 Ford F150 05-18-2011, 10:39 PM
Replies: 16
Views: 5,106
Posted By The Ford Kid
I'm getting the 5500 watt setup off DDM with the...

I'm getting the 5500 watt setup off DDM with the high low option and it's debating still on whether or not I'm doing 4500k or 5000k brightness a couple buddy's have each setup so I might rob there...
Forum: 1997 - 2003 Ford F150 05-18-2011, 10:22 PM
Replies: 16
Views: 5,106
Posted By The Ford Kid
I'll be the first to tell you when mine come in...

I'll be the first to tell you when mine come in Saturday my stock ones are all fogged up so it gave me the reason to buy Lightning ones
Forum: 1997 - 2003 Ford F150 05-18-2011, 10:15 PM
Replies: 9
Views: 2,735
Posted By The Ford Kid
Check the ball joints they are what usually cause...

Check the ball joints they are what usually cause a creaking noise
Forum: 1997 - 2003 Ford F150 05-08-2011, 11:02 PM
Replies: 20
Views: 8,244
Posted By The Ford Kid
This is my 99 I can take more if you need it from...

This is my 99 I can take more if you need it from other angles
Forum: 1997 - 2003 Ford F150 02-13-2011, 09:24 AM
Replies: 3
Views: 1,396
Posted By The Ford Kid
Check your ball joints and tie rods there known...

Check your ball joints and tie rods there known on these trucks
Forum: 1997 - 2003 Ford F150 02-13-2011, 09:21 AM
Replies: 10
Views: 1,720
Posted By The Ford Kid
Just had this on my truck we figured it out after...

Just had this on my truck we figured it out after doing all sorts of test the fuel injector went bad and ran lean causing my plug to melt in the head
Forum: 1997 - 2003 Ford F150 01-09-2011, 07:20 PM
Replies: 17
Views: 2,305
Posted By The Ford Kid
Hows the alignment on the truck? I know my dad...

Hows the alignment on the truck? I know my dad owns an auto parts store and when several hubs come back they have to prove they have had an alignment done recently because the wheel being out puts...
Forum: 1997 - 2003 Ford F150 12-02-2010, 07:55 PM
Replies: 3
Views: 905
Posted By The Ford Kid
I did a 3" block lift in the rear end of my truck...

I did a 3" block lift in the rear end of my truck the shocks still work they just dont have the same extension you only need new U-bolts
Forum: 1997 - 2003 Ford F150 11-25-2010, 12:26 PM
Replies: 5
Views: 3,420
Posted By The Ford Kid
I have the same thing on my 99' and its the fact...

I have the same thing on my 99' and its the fact that the little light inside the thing burns out and you cant just replace the light (I tried) you have to get a whole new switch
Forum: 2004 - 2008 Ford F150 06-18-2010, 11:20 PM
Replies: 0
Views: 535
Posted By The Ford Kid
2004 f-150 4.6l

Alright my dad has an electrical problem.He had a windshield put in last summer they screwed that up... it leaked all inside.I was driving the truck it stalled when i was mid turn.The next few days...
Forum: 1997 - 2003 Ford F150 05-24-2010, 03:43 PM
Replies: 5
Views: 822
Posted By The Ford Kid
Just cut the heads off the bolts if the bolts...

Just cut the heads off the bolts if the bolts don't come out easily and then use an easy out to get the rest out don't break it in the head
Forum: 1997 - 2003 Ford F150 05-07-2010, 03:21 PM
Replies: 11
Views: 4,331
Posted By The Ford Kid
Try a small local auto parts store that's where I...

Try a small local auto parts store that's where I got mine from it's worth a shot
Forum: 1997 - 2003 Ford F150 05-07-2010, 03:01 PM
Replies: 6
Views: 906
Posted By The Ford Kid
I would give LMC a shot the last catalog i was...

I would give LMC a shot the last catalog i was looking at had some
Showing results 1 to 25 of 29

 
Forum Jump

All times are GMT -4. The time now is 12:28 AM.


Copyright 2006 - 2017 F150Forum.com