Ford F150 Forum - Community of Ford Truck Fans - Search Results

Topic Sponsor
 
Search: Posts Made By: white89gt
Showing results 1 to 25 of 384
Search took 0.07 seconds.
04-18-2018, 10:47 PM
Replies: 6
Views: 198
Posted By white89gt

I agree... I lean even further that way.

I agree... I lean even further that way.
04-17-2018, 10:04 PM
Replies: 6
Views: 198
Posted By white89gt

The receiver ring does not hold programming, so...

The receiver ring does not hold programming, so yes - you can replace just the ring. However, your problem may lie in the cluster if it is acting intermittently. I would pull it and re-flow the...
04-16-2018, 06:19 AM
Replies: 16
Views: 341
Posted By white89gt

40 to 70 horsepower gain? From a Gen 10? No way...

40 to 70 horsepower gain? From a Gen 10? No way on earth.

These trucks are not going to surprise you with "hidden horsepower" from a tune. In fact, unless you've added something like heads,...
04-08-2018, 04:29 PM
Replies: 33
Views: 829
Posted By white89gt

The harness will have this connector in it. It...

The harness will have this connector in it. It should be fairly easy to patch. If I were you, I would replace that wire loom as well.
04-08-2018, 03:01 PM
Replies: 33
Views: 829
Posted By white89gt

The PCM is behind the battery. Then it goes all...

The PCM is behind the battery. Then it goes all over the place. I've never traced the harness down, but I would assume it would be pretty easy to follow the harness down to the trans and transfer...
04-08-2018, 02:43 PM
Replies: 33
Views: 829
Posted By white89gt

Unless my book is wrong, then yes that should be...

Unless my book is wrong, then yes that should be exactly the same - I got that right out of my 97 to 03 book.
03-27-2018, 08:05 PM
Replies: 6
Views: 152
Posted By white89gt

Does your truck have a tune that is blocking...

Does your truck have a tune that is blocking codes from appearing? My truck would throw a code instantly if it was doing what you are describing.

Sounds like a vacuum leak or EGR issue so far, to...
03-25-2018, 02:18 PM
Replies: 33
Views: 829
Posted By white89gt

You have the one bulkhead in your picture. It's...

You have the one bulkhead in your picture. It's been a spell, but I think the rest of it is all down on the trans and t-case.

If you can't figure it out, I can look it up when I get home - but...
03-24-2018, 07:55 PM
Replies: 33
Views: 829
Posted By white89gt

Did you find it all?

Did you find it all?
03-24-2018, 06:31 PM
Replies: 24
Views: 728
Posted By white89gt

https://cimg4.ibsrv.net/gimg/www.f150forum.com-vbu...

https://cimg4.ibsrv.net/gimg/www.f150forum.com-vbulletin/300x254/bye_felicia_28455905e0bc8e85126410d233fbbacf12e441aa.gif
03-24-2018, 10:35 AM
Replies: 9
Views: 604
Posted By white89gt

Then you'll want to follow JBrew's instructions...

Then you'll want to follow JBrew's instructions in the second paragraph for patching it up....

I've got to say that for being in New York, that doesn't look too bad for an 18 year old vehicle. I...
03-24-2018, 10:30 AM
Replies: 33
Views: 829
Posted By white89gt

BTW, I wouldn't say 100% that the wire colors...

BTW, I wouldn't say 100% that the wire colors will be correct for the diagrams. HOWEVER, the pin location will be correct. Just be aware that I've seen the wrong colors listed, depending on the year....
03-24-2018, 10:28 AM
Replies: 33
Views: 829
Posted By white89gt

Just got to thinking... you might want this one...

Just got to thinking... you might want this one for the trans harness too....
...
03-24-2018, 10:22 AM
Replies: 5
Views: 200
Posted By white89gt

If you are inquiring about this because you are...

If you are inquiring about this because you are changing your wires (and/or plugs) be cautious as to what you are putting on your truck. Motorcraft or Denso wires, and Motorcraft plugs are what these...
03-24-2018, 10:05 AM
Replies: 33
Views: 829
Posted By white89gt

In this case, shift solenoid 2 is what you are...

In this case, shift solenoid 2 is what you are after.... not sure why the terminology is different on your code you've read....
03-22-2018, 09:56 PM
Replies: 33
Views: 829
Posted By white89gt

Oh, you're right.... it's under the dash. My bad...

Oh, you're right.... it's under the dash. My bad - sorry. Fuse number 2, under the dash.
...
03-22-2018, 05:03 PM
Replies: 33
Views: 829
Posted By white89gt

I believe it is fuse number 2 in the box under...

I believe it is fuse number 2 in the box under the hood. It also runs the instrument cluster though, so you might have something else wonky.
03-16-2018, 08:30 AM
Replies: 17
Views: 527
Posted By white89gt

Good deal. See you later. You want everyone...

Good deal. See you later.

You want everyone to do your research for you.... and get pissed when it doesn't happen.
03-14-2018, 09:19 AM
Replies: 19
Views: 711
Posted By white89gt

Now that you've done that, you may want to try...

Now that you've done that, you may want to try resetting the ECU. disconnect the battery for about 20 minutes, and then see if it helps.
03-14-2018, 06:33 AM
Replies: 25
Views: 722
Posted By white89gt

Ooops.

Ooops.
03-12-2018, 03:16 PM
Replies: 16
Views: 598
Posted By white89gt

I've never seen one without it... maybe later it...

I've never seen one without it... maybe later it was moved to the instrument cluster though (anyone know for sure?). There will be a button on the end of the shifter - push it and see if it turns on....
03-12-2018, 03:00 PM
Replies: 16
Views: 598
Posted By white89gt

Pretty much all the time.... possibly changing...

Pretty much all the time.... possibly changing sounds when gears are changed/applied - but since it's not engaging, probably just constant. However..... it could also make a chattering sound and be...
03-11-2018, 08:20 PM
Replies: 28
Views: 1,261
Posted By white89gt

My bad... I was thinking with my head up my...

My bad... I was thinking with my head up my butt.... you are correct.... AK is probably correct.
03-11-2018, 07:17 PM
Replies: 16
Views: 598
Posted By white89gt

I agree, sounds like the pump to me. Does it...

I agree, sounds like the pump to me. Does it whine?
03-11-2018, 07:15 PM
Replies: 28
Views: 1,261
Posted By white89gt

If there are no rocker arms, all of the valves...

If there are no rocker arms, all of the valves are closed. No place for the compression to go. I guarantee this is his issue.
Showing results 1 to 25 of 384
 


 
Forum Jump

Contact Us Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.