Ford F150 Forum - Community of Ford Truck Fans - Search Results

Topic Sponsor
Search: Posts Made By: Good old Bill
Showing results 1 to 19 of 19
Search took 0.01 seconds.
12-03-2017, 09:54 AM
Replies: 2
Views: 209
Posted By Good old Bill

Sounds like a plan. Don't get discouraged if...

Sounds like a plan. Don't get discouraged if its harder than it sounds. Double check fittings first.
11-18-2017, 05:13 PM
Replies: 5
Views: 1,116
Posted By Good old Bill

4WD light stays on

Am not familiar with the vacuum operated systems, but vacuum, electrical or mechanical operation, something has to move the shift lever to engage 4WD. So disconnect all that junk and move the lever...
12-18-2013, 08:06 PM
Replies: 17
Views: 3,483
Posted By Good old Bill

Its time to start using the 12 volt test light. ...

Its time to start using the 12 volt test light. Do you have 12 volts when in the high beam position, basic trouble shooting is in order here. It is possible you have two high beam bulbs out. And...
11-07-2013, 11:14 PM
Replies: 4
Views: 610
Posted By Good old Bill

You are really taxing this old guys brain. The...

You are really taxing this old guys brain. The 79 ended a body style and 80 started another. Am not sure about the power windows, surely in the early eighties we had power windows.
10-23-2013, 03:57 AM
Replies: 10
Views: 1,400
Posted By Good old Bill

Its common for a carburated engine to load up on...

Its common for a carburated engine to load up on fuel during deceleration and cause popping in exhaust.

Remove #1 spark plug and use a wire to locate TDC thru plug hole. Mark your balancer at...
10-22-2013, 03:25 PM
Replies: 6
Views: 852
Posted By Good old Bill

If you haven't already removed belt and run...

If you haven't already removed belt and run engine with belt off, do so. Remember, the water pump will also not be turning so don't run engine very long. Hoping for an accessory bearing bad,...
10-16-2013, 11:14 AM
Replies: 1
Views: 359
Posted By Good old Bill

We all do stupid things, don't sweat it. I...

We all do stupid things, don't sweat it. I haven't seen that code or description before, but taking it for what its worth, verify if engine is running hot. If not, erase code and retest. If its a...
10-15-2013, 07:02 PM
Replies: 6
Views: 2,028
Posted By Good old Bill

I agree with Marc on the pick up coil inside the...

I agree with Marc on the pick up coil inside the distributor, the Dura spark ignition system had the ignition module mounted on the fender. Go to a reliable Auto parts house for the replacement. ...
05-21-2013, 06:48 PM
Replies: 8
Views: 606
Posted By Good old Bill

Hi Buddy, its been a long absence for me and have...

Hi Buddy, its been a long absence for me and have forgotten how to reply on the forum. Please stay with me. Shift points are way off. My 02 4.6L (236K), I will be in OD by 2000RPM and 40 MPH. I...
03-21-2013, 04:24 PM
Replies: 2
Views: 432
Posted By Good old Bill

Your next step would be to perform a wet/dry...

Your next step would be to perform a wet/dry test. This is simple to do, just squirt some oil into the low cylinder (thru plug hole) and retest. If reading gets higher (significantly) your problem...
07-02-2012, 10:09 PM
Replies: 2
Views: 448
Posted By Good old Bill

It does sound like a pump failure is emminent. ...

It does sound like a pump failure is emminent. If possible, carry a spray can of starting fluid, when it quits again spray some fluid into the intake, it it pops off, at least you have seperated...
06-06-2012, 04:59 PM
Replies: 17
Views: 40,387
Posted By Good old Bill

A leaking dump valve in the ABS hydraulic unit...

A leaking dump valve in the ABS hydraulic unit will act the same as a bypassing master cylinder, exception being with the ABS valve bypassing, the pedal only goes to the same low spot, time after...
06-03-2012, 08:28 AM
Replies: 1
Views: 2,462
Posted By Good old Bill

Good morning and welcome to the fun. I would...

Good morning and welcome to the fun. I would think your best option is to visit junk yards. Stay away from current stores, they want your money not give you results. I presently have a column...
08-28-2009, 04:26 PM
Replies: 1,348
Views: 536,556
Posted By Good old Bill

https://www.f150forum.com/attachment.php?attachmen...

https://www.f150forum.com/attachment.php?attachmentid=2857&stc=1&thumb=1&d=1232462416 (https://www.f150forum.com/attachment.php?attachmentid=2857&d=1232462416)
06-04-2009, 08:16 PM
Replies: 16
Views: 22,213
Posted By Good old Bill

Tend to get lost in long threads that seem to go...

Tend to get lost in long threads that seem to go no where. Does this thing go into reverse or not? The TV cable has no bearing on the reverse engagement. Has more to do with shift points. Please...
04-19-2009, 07:33 PM
Replies: 7
Views: 4,393
Posted By Good old Bill

Here I looked it up, F65Z 18663 AC. Hope this is...

Here I looked it up, F65Z 18663 AC. Hope this is the correct one. Check the pic by mich655 on 3-18-2009.
04-10-2009, 08:09 AM
Replies: 36
Views: 55,323
Posted By Good old Bill

What is blend door, I will try to be brief. In...

What is blend door, I will try to be brief. In todays trucks there is water flowing through the heater core at all times, no water shut off valve. So they use a door to mix or blend air flow across...
11-24-2008, 04:00 PM
Replies: 67
Views: 56,353
Posted By Good old Bill

Rieker, buy a pencil type soldering iron, not the...

Rieker, buy a pencil type soldering iron, not the gun. They take a little more time to heat up, but are much handier to use with this finer circuitry. Also recommend a fine wire type solder not the...
06-13-2008, 08:39 AM
Replies: 3
Views: 4,595
Posted By Good old Bill

Assuming you are speaking of slow to fire up and...

Assuming you are speaking of slow to fire up and not slow to crank with the starter, I would recommend checking the fuel pressure again and watch how long pressure is maintained after engine is...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.