Ford F150 Forum - Community of Ford Truck Fans - Conversation Between jrmatson8 and jerrybizzle

Conversation Between jrmatson8 and jerrybizzle
Showing Visitor Messages 1 to 9 of 9
  1. jrmatson8
    01-07-2012 05:31 AM - permalink
    how did you go about bedlining your bumpers? i got some rust on the insides of mine and i might just go this route..
  2. jrmatson8
    12-29-2011 04:02 AM - permalink
    thanks i appreciate it! looks like a very well done weld job, nice!
  3. jerrybizzle
    12-28-2011 11:26 PM - permalink
    It's a little dirty under there, but here are the pics u wanted.
  4. jerrybizzle
    12-28-2011 05:53 PM - permalink
    Got lazy last night as I didn't feel like crawling under there. I will get it done tonight and post a pic.
  5. jrmatson8
    12-28-2011 05:12 PM - permalink
    hmm alright. yeah if it wouldn't be too much trouble a pic would be nice
  6. jerrybizzle
    12-27-2011 03:03 PM - permalink
    Had the shop weld it in. I'm at work now, but can take a picture for u later when I get home if u want. I didn't clamp it at all. Have always had it welded in.
  7. jrmatson8
    12-27-2011 02:24 PM - permalink
    so how'd you get the intermediate pipe up to 3" w/o putting a new y-pipe on off the cats?
  8. jerrybizzle
    12-27-2011 10:18 AM - permalink
    Bumped the piping to 3 inch cat back. Didn't change the y pipe. 18 inch long 4 inch tip. I have the muffler near the rear axle so drone is very minimal. It is loud enough for me. It has a nice growl throughout the rpm range and isn't loud when cruising. I can still hear it when driving around 40 and the rpms are around 1200 or so. Couldn't hear the old setup at low rpms or over 3000. 40 for the muffler off of Amazon. Well worth it. Let me know if u have any other questions.
  9. jrmatson8
    12-27-2011 01:02 AM - permalink
    what's the exact set up of your exhaust? it sounds great.
    did you change the factory y-pipe to 3" mid pipe, etc etc?
    also, is it loud enough for you? i'm concerned i may be disappointed with a si/so. thanks!

All times are GMT -4. The time now is 06:15 PM.

Copyright 2006 - 2017 We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.