Greg Owen Greg Owen is offline

Weekend Warrior!

About Me

  • About Greg Owen
    Country of Residence
    US
    Gender
    Male

Statistics

Total Posts
Albums
Visitor Messages
Total Likes
General Information
  • Last Activity: 01-04-2022 07:54 PM
  • Join Date: 03-15-2011

Visitor Messages

Showing Visitor Messages 1 to 6 of 6
  1. Tevans@danieldefens1
    01-16-2022 05:57 AM - permalink
    Hey Greg, I saw a post about your light bar on your ranch hand a few years back could you tell me the size of the light bar?
  2. samhadley19
    06-05-2020 03:36 PM - permalink
    Hey Greg, When you were adding the power sliding window for your truck, where was the wires for the switch located. I'm working on installing mine and cannot find the wire.
  3. booboo55
    07-22-2016 08:56 AM - permalink
    Hi Greg, I was wondering if you ever found that little trim piece for the switch on that power rear slider you installed? Great job by the way.
  4. Grandpa's Grocery Getter
    07-30-2013 08:23 PM - permalink
    HI Greg,

    the Moon/sun roof is 700series top of the line, it has 3 position sunroof opening, Auto close when key is turned off but can be stopped with a touch of the button. The Custom shop that did mine made it look factory.

    My Buddy has New 2013 FX4 Luxury and his moon roof doesnot have auto close and mine is suppose to have 2 hr close if you happen to leave it opne, but that hasn't happened to me yet, might be something with the programming.

    Its has Nice laminated Ble for the switich and matches the dash at nite

    hope that helps

    Grant
  5. Greg Owen
    02-22-2013 04:34 PM - permalink
    I wish I could help you out. My window came all assembled with the motor & cable, so I didn't have to mess with it. Sorry...
  6. Stone Roots
    02-12-2013 09:26 PM - permalink
    Can you give any insight on replacing a motor and cables for a power sliding rear window? I bought a new unit but it doesn't seem like there is enough cable to connect to both sides if the window. I tried to extend some cable out hoping there was slack in the drum and all the cables inside the drum became loose and came off. It's been extremely frustrating and I can't find any other information on how to install this motor and cable assembly correctly...

All times are GMT -4. The time now is 07:24 PM.