Voltage tap Hot with IGN
#1
Senior Member
Thread Starter
Voltage tap Hot with IGN
Any suggestions for a fuse tap in the under the hood box to get 12v with ignition on , not on with Accessory. 1996 F150 XL 4.9. I need only a couple amps,so it shouldn't matter much to the circuit I'm borrowing
from.
from.
#2
Senior Member
Thread Starter
For archival purposes I'll answer myself, after a bit of trial and error. I found E (15amp) to meet the requirements. The lid had to be modified a little to accommodate the tap and wire. I could have modified the box for the wire exit, but I can replace the lid a lot easier than the box.
#3
Member
Join Date: Jan 2018
Location: Memphis, TN, Earth, Milky Way
Posts: 11,256
Received 1,731 Likes
on
1,487 Posts
I usually just solder a new wire to the bottom of the fuse terminal, and run it with the factory harness to wherever I need. It's relatively easy to flip the PDB, slide the cover off, and work on the terminals.
(phone app link)
(phone app link)
#4
Senior Member
Thread Starter
I usually just solder a new wire to the bottom of the fuse terminal, and run it with the factory harness to wherever I need. It's relatively easy to flip the PDB, slide the cover off, and work on the terminals.
(phone app link)
(phone app link)