Turn signal issue...
#1
NAVY Jet Engine Mechanic
Thread Starter
Turn signal issue...
Normally when I turn signal bulb fails and is burnt out the one that still works will blink rapidly right?
My issue is this, both the driver side turn signals work. When I use the right singal, it flashes like it should, but I am not getting any flashes from the front right. So I looked at the bulb, it was fine. I even switched the left for the right because I know the left was good, still nothing. The right bulb is still actually good. I checked fuses and relays, and nothing. Even using the hazard lights, all markers flash normal except the right front.
Does anyone have any suggestions or have had this happen to them?
TIA
My issue is this, both the driver side turn signals work. When I use the right singal, it flashes like it should, but I am not getting any flashes from the front right. So I looked at the bulb, it was fine. I even switched the left for the right because I know the left was good, still nothing. The right bulb is still actually good. I checked fuses and relays, and nothing. Even using the hazard lights, all markers flash normal except the right front.
Does anyone have any suggestions or have had this happen to them?
TIA
#2
Senior Member
Best thing to do...
Pull the bulb connector for the left front that's working and use a test light to find the the wire sending the flasher signal. Now pull the connector for the right side and check the same wire. If you aren't getting the same signal then start tracing that wire back as far as you need to until you find the break in the connection.
Pull the bulb connector for the left front that's working and use a test light to find the the wire sending the flasher signal. Now pull the connector for the right side and check the same wire. If you aren't getting the same signal then start tracing that wire back as far as you need to until you find the break in the connection.