Looking for the location of a splice
#1
Junior Member
Thread Starter
Join Date: Mar 2016
Location: 2117 Elly Rd. Aroda,Va. 22709
Posts: 9
Received 0 Likes
on
0 Posts
Looking for the location of a splice
1992 F-150 Well I found my vacuum leak with propane,it was the throttle body gasket. But it was still idling to high and sending out a KOER code 412.
Vacuum is steady @ 21". I checked everything and tested all of the sensors and they were ok.
When I checked the voltage at the ISC connector I only got 2.45 volts but it dropped to 0 and the same for the EGR connector. In the electrical schematic at 25-B it shows a splice, the same one the injectors get power from(and they all work). Does anyone know where that splice is located?
Vacuum is steady @ 21". I checked everything and tested all of the sensors and they were ok.
When I checked the voltage at the ISC connector I only got 2.45 volts but it dropped to 0 and the same for the EGR connector. In the electrical schematic at 25-B it shows a splice, the same one the injectors get power from(and they all work). Does anyone know where that splice is located?
Last edited by ward74; 03-19-2016 at 11:22 AM.
#2
Senior Member
iTrader: (1)
I had an engine wiring harness from a v6 ranger, also speed density and it had 2 wires which were each spliced to 3 that went to the injectors.
On that particular one, the splice for the injector wires (3 & 3)was partway into the engine harness.
Totally hidden away inside the harness.
I have no idea why they would do that there, but they did.
Doesn't necessarily apply to yours, but you could have something similar.
On that particular one, the splice for the injector wires (3 & 3)was partway into the engine harness.
Totally hidden away inside the harness.
I have no idea why they would do that there, but they did.
Doesn't necessarily apply to yours, but you could have something similar.