Alright, first post. Just did a bunch of front end work (drag link steering, ball joints, shocks, axle pivot bushings). Picked it up from the alignment shop this morning and they said the axle pivot bushings are shot. I know they're not shot, or if they are it's due to an installation issue on my end. The only miles on them are from my house to the alignment shop. The symptoms the were seeing (they pointed them out, they're there) was it throwing the camber way off and pulling the steering, likely because the axle is not holding tight to that pivot point. They are OEM rubber bushings that are pressed in fully, and I torqued the bolts to spec. Any ideas on what could be going on here? Thanks in advance folks