Valve Cover
#1
Senior Member
Thread Starter
Valve Cover
Hey guys a dumb question. I have 300 6 would a valve cover from a 200 fit? I realize that the 200 is shorter but are they the same length. Haven't found a descent looking 300 one yet. Appreciate the support.
#2
Senior Member
No but if in doubt go to parts store and compair gaskets
#3
Senior Member
Go into Orielly's website and look up parts for both engines.
#4
Senior Member
The 240/300 Big block 6 and 144/170/200 Small block 6 are two different engine families with very little interchange of parts. The 250 is based on the small block but it is slightly different and larger than its smaller siblings.
That being said I'm not 100% sure that the valve covers are different but would be very surprised if they were not.
Regards
rikard
That being said I'm not 100% sure that the valve covers are different but would be very surprised if they were not.
Regards
rikard
#6
Senior Member
Thread Starter
I figured that was the case. Just trying to dress up my little six. Only thing that I have found was just a chrome valve cover... not what I want.
Trending Topics
#9
EFI and clifford valve cover
I see that these postings are pretty old, but has anyone purchased a Clifford valve cover and successfully made it fit to an EFI 4.9L? Clifford states that there are clearance issues because of the intake manifold so they don't make them for the EFI, just had to see if anyone had taken the leap and made it work.
Crossing my fingers for good reports.
Crossing my fingers for good reports.
Last edited by Red4.9L; 12-21-2012 at 02:59 PM.