So I’ve removed the Schrader valve off of fuel rail connected fuel gauge still getting zero reading ordered new selector switch should be here this weekend other than that. Nothing new.

also install new zero gauge ground wire to engine block

 

Will be testing for codes when I get back to the house will advise when I’m done

 

126 ,522,10,111 are the codes coming up and because truck is not running ran test with just key turned

Their are two 126 one is map that I ordered today and other says cylinder, identification circuit failure

522 is vehicle not in park but vehicle was a manual so I’m not really worried about that one

10 is cylinder one has a problem

111 says system good

 

The truck is running but fuel rail still says 0

 

Is it running ok? There's got to be something wrong with the fuel pressure gauge or it's connections. If it's running good, that's all that matters.

 

I haven’t taken it for a drive yet but it has been sitting for over a 1yr and the motor is a little rough but think it should clean up after driving it
but have to put the bed back on before driving around