94 4.9 Liter valve seal question
#1
Loves Fords
Thread Starter
Join Date: Jan 2017
Location: Manchester
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
94 4.9 Liter valve seal question
Hi all,
I am doing valve guide seals on this motor. I have 120 psi piped in to the cylinder along with the motor rotated to the cylinder I am working on firing according to the rotor/diagram. If one of these valves falls in I am going to have a very bad day. Is there anyway I can determine if the piston is at TDC other than a borescope? Will compressed air be enough to hold the valves up? Thanks...Joel
I am doing valve guide seals on this motor. I have 120 psi piped in to the cylinder along with the motor rotated to the cylinder I am working on firing according to the rotor/diagram. If one of these valves falls in I am going to have a very bad day. Is there anyway I can determine if the piston is at TDC other than a borescope? Will compressed air be enough to hold the valves up? Thanks...Joel
#3
Member