TheRetrofitSource Group Buy
#761
Yes that's the harness, but they don't description which is ground/high/low. I'll dink around with the light bulb, I was using the center as a ground then so I'll see if I move the ground to the outside if it to work or not. I supose I could just call trs tomorrow
#763
Called trs and was told white is ground brown is low, gerring a little anxiouse to get this underway. That's the cheap bulb, once complete I'm going to wait a while to put in the nightbreakers
#764
Senior Member
Dumb question... you guys that used mini 7.0's... I started playing around with mine, but the projector sits out so far the mini graphite shroud doesnt come close to touching the reflector. I saw another thread on these, he had to trim panamera shrouds I believe to fit flush. Short of cutting out alot and using bolts, Im kind of at a loss right now.
#765
BAMF Club
Thread Starter
You have to get another shroud, recess the projector, or make some shroud extensions to cover the gap.
#766
Senior Member
#767
Senior Member
Got my high beams working again. I swapped the new motocontrol box in but had the same result until I took every connection back apart and found the issue. Apparently, when I had the ballast issue, when I disconnected and reconnected everything, the pins on the harness to the main headlight plug all bent just enough to slide into the lower slots instead of the upper slots. Straightened them back out to align properly and everything worked.
The following users liked this post:
ak_cowboy (06-11-2016)
#768
Good deal. Out of curiosity, has anyone experimented with adjusting the headlights. What I'm curiouse of is when you adjust verticle, will it throw off the rotation at all (09-14) from pivoting?
#769