Ranch Hand Sport Rear Bumper Licence plate Lights
03-15-2017, 10:26 PM
#1
Junior Member
Thread Starter
Join Date: Mar 2017
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Ranch Hand Sport Rear Bumper Licence plate Lights
Lights that came with the bumper only have 1 wire. Old harness has two. Cut off the connector on harness on one side and attempted to wire the old harness to the new one wire bulb. It didn't work, any suggestions? Really would like to avoid getting a ticket for not having those lights wired up.
03-16-2017, 08:32 AM
#3
Junior Member
Thread Starter
Join Date: Mar 2017
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Yes, tried both to be sure. Is it possible the light isn't getting grounded through the powder coat on the bumper? If so how do I solve short of scraping the bumper. Seems like a flawed design if that's the case.
03-18-2017, 06:12 PM
#5
Junior Member
Thread Starter
Join Date: Mar 2017
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
SOLUTION: Turns out that it was an issue with the powder coat preventing the light from grounding. Sanded the inside of the light holes down with some medium grade sand paper and lights now work!
02-24-2019, 01:00 PM
#7
Hey, on the Ranch Hand rear bumper, how do you change the license plate bulbs? Does the whole fixture pop out the front, or do you remove the bulb from behind the bumper??? (I obviously didn’t install the bumper)
Thanks in advance!
Thanks in advance!