2018 DT moto Headlight H7 bulbs?
#1
2018 DT moto Headlight H7 bulbs?
I order the new headlights for the halogen equipped xlt
Thanks,
Dan
https://www.amazon.com/gp/product/B07NYVPF5N?pf_rd_p=1581d9f4-062f-453c-b69e-0f3e00ba2652&pf_rd_r=ZHSK36V2WFWHEYX3XM0X
however since im in canada they do not sell the ones with leds included meaning i gotta buy some leds for the low and high beams. i bought a set for my oem set from f150leds.com and they probably will not fit in the housing. i dont think they are h7. question is with a h7 led do i need to have any resistors or antiflicker kit. The service department at my local stealership said i gotta be careful hooking up leds regarding them frying electrical??? im not sure if hes talking out of is A** but i need some input on all this. any thing is appericated,Thanks,
Dan
#4
Member
I also just ordered these headlights (but I ordered direct from AlphaRex website. Got the sequential ones. I'm going to need some LED's as well, but I actually have a set of Katana LED H7 from my other car. I'm going to pull them to see if they fit. I'll measure see how they fit, then we have ideas of what to order.
Only problem is that I don't have the units, nor the truck to even put them in. Supposed to get truck this week, but have to go out of town next week.
Might be a few weeks before I get to this.
Only problem is that I don't have the units, nor the truck to even put them in. Supposed to get truck this week, but have to go out of town next week.
Might be a few weeks before I get to this.
#5
Member
How does something like this fit into the housings of aftermarket projector units?
Does the whole thing fit inside the housing, or do you end up having to keep parts outside, and then drill through the rubber caps?
Thinking about these now for the low beams.
Does the whole thing fit inside the housing, or do you end up having to keep parts outside, and then drill through the rubber caps?
Thinking about these now for the low beams.
Last edited by ymeski56; 09-26-2019 at 12:51 PM.
#6
As with any HID kit, you have to make a hole in the cap for the bulb wires to run through, as there is a ballast unit which will not fit in the headlight housing.
Last edited by ymeski56; 09-26-2019 at 12:51 PM.