2012 Driver Tail Light Turn Signal out
08-05-2017, 09:05 AM
#1
Ski Bum
Thread Starter
2012 Driver Tail Light Turn Signal out
decided to upgrade to LED's all around, installed with crimped on resistors, everything was fine for 2 weeks, now driver rear turn signal is out (parking light still works) got fed up after checking all connections and pulled everything out to return to halogen, some wires looked questionable, so i cut all of them and re-soldered. 
STILL NO TURN SIGNAL!!!! Fuse is still good, anyone with any other ideas why after being returned to stock I'm not getting a turn signal?? any input would be much appreciated as I'm not very savvy when it comes to wiring and already regret going the DIY resistor route in the first place.
STILL NO TURN SIGNAL!!!! Fuse is still good, anyone with any other ideas why after being returned to stock I'm not getting a turn signal?? any input would be much appreciated as I'm not very savvy when it comes to wiring and already regret going the DIY resistor route in the first place.
08-05-2017, 09:07 AM
#2
Mark
iTrader: (1)
Try a new flasher unit/relay
08-05-2017, 09:35 AM
#3
Senior Member
08-05-2017, 11:48 AM
#4
Mark
iTrader: (1)
Humm.. rockauto shows a turn signal relay for an 09 an EP-27.
Last edited by techrep; 08-05-2017 at 11:55 AM.
08-05-2017, 12:18 PM
#5
Ski Bum
Thread Starter
Thanks for the Quick replies guys, I'm not sure if its a flasher relay issue or not (or if our 2012 models even have that quick fix idea, I looked into it before going the resistor route) my front turn signal on the drivers side still works fine, hyper flashing now due to the rears being out, also the passanger side is functioning with the resistors in as normal. Its currently nuking rain all day here, once it drys out I'll try climbing under the truck to check the grounds from the harness, but I feel like that too would put all of the lights out if it was bad.
08-05-2017, 01:04 PM
#6
Mark
iTrader: (1)
Oh.. he has a 2012.. that may be different.
08-05-2017, 01:14 PM
#7
11-14 and probably newer use a body control module for the flasher, there are individual fuses on the bcm for each side.
.
.
Trending Topics
08-05-2017, 02:12 PM
#8
Ski Bum
Thread Starter
RnlComp, thanks for the diagram, I'm not very familiar with reading these though, where might I find a fuse for the left rear turn signal/stop lamp to check if its blown? Per my truck manual, it shows that the fuse for the parking light is the same as the turn signal.
08-05-2017, 02:19 PM
#9
Looks to be F14 on the body control module, passenger side kick panel. I'd check them all just to be sure with a computer safe test light or dvom.
.
.
The following users liked this post:
RubberDuckie (08-05-2017)
08-05-2017, 03:26 PM
#10
Ski Bum
Thread Starter
