101 ways to mount your Rigids! - Presented by TAP Auto and goneFXcrazy
#133
Senior Member
#134
Member
Thread Starter
They shouldn't be, I can provide with some detailed measurements on how much clearance you will need. By all accounts, drilling a hole in each side and passing the bolts through that hole should do it.
The following users liked this post:
Laxman09 (12-31-2014)
#135
Senior Member
The following users liked this post:
goneMINIcrazy (01-01-2015)
#136
Member
Thread Starter
[MENTION=180865]Laxman09[/MENTION] You're looking at a required 31.5inches from end to end required to fit an E Series bar, and 31.675inches to fit an SR Series Bar. Those sections are narrow as I'm sure you've noticed, you will just need to get creative with the hardware. The bolts themselves are fairly narrow too, but some nuts and heavy duty washers will be your best friends.
#138
Senior Member