TunaSlayer Mod Progress
#463
Senior Member
Tuna, I have a 2010 fx4. I'm looking for the correct size level kit to make it perfectly level. I don't think I want to go any higher in the back. Looks like you did 2" up front. Is that what you would recommend? On that note it looks like your AAL mod put back the factory rake so you effectively raised your 2" overall with stock rake?
#466
Offshore Poster
Thread Starter
Tuna, I have a 2010 fx4. I'm looking for the correct size level kit to make it perfectly level. I don't think I want to go any higher in the back. Looks like you did 2" up front. Is that what you would recommend? On that note it looks like your AAL mod put back the factory rake so you effectively raised your 2" overall with stock rake?
So what's next tuna?
Indeed what good lookin' Truck! That there Custom Rod Holder is the best!
#467
Junior Member
Join Date: Apr 2010
Location: Southeast Texas
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by TunaSlayer
Ok so last week I took the FORD tail gate emblem off to spray black but right at the last minute I decided to liner it with some left over cans I had. I liked the texture, but when the sun hit it it wasn't jet black enough. Today I sprayed a top coat of black on and really like the outcome. Went and did the F150 emblem on the gate as well. Tomorrow I'll do the fender emblems.
Last week, just liner
Today
This is the Sem Solve stuff I always mention. Great prep solution
Last week, just liner
Today
This is the Sem Solve stuff I always mention. Great prep solution
#468
Offshore Poster
Thread Starter
What did you use to paint it? It's the same emblem. They have a protective clear film over them (you can see it bubble up on some people's emblem) that I took time to peel off with a razor before painting. When that's off you can literally scrape the blue paint off with your fingernail. Maybe the lettering is more raised when it's removed.
#470
Senior Member
Join Date: Nov 2010
Location: Bountiful Utah
Posts: 256
Likes: 0
Received 0 Likes
on
0 Posts
My emlem sticker was peeling up and looked horrible i took a heat gun to it to remove it then i sanded them down a little not sure if i needed to but i did and i also cleaned off the blue paint with finger nail polish remover on a rag that worked good for me and i did mine while they were on the truck i was lazy oh well