SDDesigns 2018 SCrew XLT 4X4 5.0 Supercharged "50WOT"
#211
Doesn't matter!
Thread Starter
Just received my OZ delivery, finished the vehicle calibration download and sent off the file for the tune.
Now I just wait!
Now I just wait!
The following 4 users liked this post by sddesigns:
#212
Doesn't matter!
Thread Starter
Finally got the Bilsteins installed tonight and the undercarriage sprayed with Fluid Film for the winter weather due our way this weekend.
Some measurements Before and After.
Driver Side Front Before
Driver Side Front After Full 2.1" Setting
Passenger Side Front Before
Passenger Side Front After Full 2.1 Setting
I'll get some exterior after shots in the morning, I did a side view before earlier today.
Some measurements Before and After.
Driver Side Front Before
Driver Side Front After Full 2.1" Setting
Passenger Side Front Before
Passenger Side Front After Full 2.1 Setting
I'll get some exterior after shots in the morning, I did a side view before earlier today.
The following users liked this post:
johnday in BFE (01-15-2019)
#213
Doesn't matter!
Thread Starter
The Final installation Shots!
The following 2 users liked this post by sddesigns:
johnday in BFE (01-15-2019),
OCMike (01-16-2019)
The following users liked this post:
sddesigns (01-16-2019)
#215
Doesn't matter!
Thread Starter
Thanks, Andrew they were supposed to have been done last week but as life goes, we got the struts shocks alignment and undercarriage sprayed in under 2 1/2 hours.
#216
Senior Member
Originally Posted by sddesigns
Thanks, Andrew they were supposed to have been done last week but as life goes, we got the struts shocks alignment and undercarriage sprayed in under 2 1/2 hours.
The following users liked this post:
sddesigns (01-16-2019)
#217
Doesn't matter!
Thread Starter
That's a pretty good time considering just doing the front coil overs on my 13 took me about 8 to do. I had a few stubborn bolts that wouldn't come loose for me. However, I went out and bought the Milwaukee fuel high torque 1/2 impact for next time lol. If that thing can't get it out then it's gonna need to be cut out.
#218
Senior Member
Originally Posted by sddesigns
My buddy has full-service automotive shop with 6 lifts and alignment rack, we do most work on my vehicles after hours and he's the only one I trust to do anything I'm incapable of doing. I'm not a mechanic by any stretch of the imagination, I'm a bolt on stuff driveway kinda installer you know oil changes minor wiring and custom stuff.
#219
Doesn't matter!
Thread Starter
I'm not a mechanic either. I'm more than capable of doing pretty much anything if I have the right equipment though. I've done a few lift kits in the past, but I don't have access to a lift. I do work in a shop but since I work for an insurance company I can't use the lift.
#220
Doesn't matter!
Thread Starter
Have my side view comparison shots.
Before
After
Before
After