SDDesigns 2018 SCrew XLT 4X4 5.0 Supercharged "50WOT"
#111
Doesn't matter!
Thread Starter
The sun never came out today, so these are the best pictures before the snow tomorrow.
The following 3 users liked this post by sddesigns:
#112
Doesn't matter!
Thread Starter
Early Christmas present from the better half!
Romik RAL-TB Running Boards!
Romik RAL-TB Running Boards!
Last edited by sddesigns; 12-22-2018 at 05:36 PM.
The following users liked this post:
Firerunner (12-22-2018)
#113
Doesn't matter!
Thread Starter
Then headed to the local hand wash for a quick First Day of Winter Detail considering it was above 40°!
#114
Village Sociopath
iTrader: (1)
Join Date: Jun 2014
Location: Nowhereville Barton City Michigan
Posts: 28,528
Received 10,073 Likes
on
6,507 Posts
You had quite the banner day, eh? Boards and truck look good.
The following users liked this post:
sddesigns (12-22-2018)
#115
Doesn't matter!
Thread Starter
#116
Doesn't matter!
Thread Starter
Brown Truck showed up today with some last minute items delayed from Santa!
RBP RX-2 Locking Fuel Door and (24) Gorilla M14x1.5 Lugnuts!
RBP RX-2 Locking Fuel Door and (24) Gorilla M14x1.5 Lugnuts!
#117
Village Sociopath
iTrader: (1)
Join Date: Jun 2014
Location: Nowhereville Barton City Michigan
Posts: 28,528
Received 10,073 Likes
on
6,507 Posts
Crap!! I keep forgetting to get some Go-Rilla nuts. Want to replace the OEM before I get into trouble.
Did you get your Autostop Eliminator in? I did mine yesterday.
Did you get your Autostop Eliminator in? I did mine yesterday.
Last edited by johnday in BFE; 12-28-2018 at 07:16 PM.
#118
Doesn't matter!
Thread Starter
The following users liked this post:
johnday in BFE (12-28-2018)
#119
Senior Member
Post up when you install the fuel door! I need one for my truck. On the Canyon we would just use a 2" Qwik Cap but the Ford fill hole has the raised yellow surround that may complicate things.
And you both are really onto something with the Autostop Eliminator. Personally, I can think of worse things than reaching over and pressing the button, but the button sometimes really takes some force to actuate and it would be nice to have the Eliminator. A little apprehensive about taking apart the centre bezel, though.
And you both are really onto something with the Autostop Eliminator. Personally, I can think of worse things than reaching over and pressing the button, but the button sometimes really takes some force to actuate and it would be nice to have the Eliminator. A little apprehensive about taking apart the centre bezel, though.
The following users liked this post:
sddesigns (12-29-2018)
#120
Village Sociopath
iTrader: (1)
Join Date: Jun 2014
Location: Nowhereville Barton City Michigan
Posts: 28,528
Received 10,073 Likes
on
6,507 Posts
It's pretty easy to do. I have a couple sets of the plastic trim tools, and used that to pop the tray loose, lift the front of it up, used a ratcheting boxwrench on the two 7mm screws, unplugged, stuck the Eliminator in, and closed everything up. I was careful though, temps were below freezing, and I sure didn't want to snap any plastic. 10 minute job at most.