OCMike's RCSB Guard Metallic 5.0 Build
#301
TOTM Sept. '18
Thread Starter
iTrader: (1)
Mike
#302
TOTM Sept. '18
Thread Starter
iTrader: (1)
I did need to change these two lines in Forscan on the APIM. I did this prior to installing the bezel. After that it was just plug and play and it just worked. Dual zone has the appearance of functioning but I don't think it actually does without the additional Lariat hardware.
Mike
Last edited by OCMike; 06-12-2018 at 08:38 PM.
#303
Senior Member
Same reason those who want manual Trans can't yet them, short of swapping one. Not enough people do want them. Chevy seems to sell more regular cabs than ford, at least around me. Maybe that's why they seem to offer them a little more upscale trimmed.
love regular cabs. You've got a great job done with yours.
love regular cabs. You've got a great job done with yours.
The following users liked this post:
OCMike (06-13-2018)
#304
TOTM Sept. '18
Thread Starter
iTrader: (1)
I wired up the Raptor shift paddles and took out on a private farm road and flogged it.
It shift better automatic LOL...Still they are fun.
Mike
It shift better automatic LOL...Still they are fun.
Mike
Last edited by OCMike; 06-15-2018 at 07:52 PM.
The following 3 users liked this post by OCMike:
#305
Village Sociopath
iTrader: (1)
Join Date: Jun 2014
Location: Nowhereville Barton City Michigan
Posts: 28,528
Received 10,073 Likes
on
6,507 Posts
Good job Mike, sure sounds good. What was that rattling?
#306
TOTM Sept. '18
Thread Starter
iTrader: (1)
It was just my E-Pass transponder in the console. I also had an iPad in there that operates the action camera I think they were banging together. That was my first venture into the action camera relm. I need to get a more solid mount. Plus that road is very rough too.
Mike
Mike
The following users liked this post:
johnday in BFE (06-15-2018)
#308
Senior Member
good looking truck and nice job with it
The following users liked this post:
OCMike (06-15-2018)
#309
On down the highway
iTrader: (4)
Mike, saw your post about plastidip for the X4 bed cover and had an idea. Didn't want to clutter that thread but here's my idea to cover the crummy looking ends. Get a thin rubber strip, silicone it to the tailgate. Flat end backing up to the x4 to hide the edge, curved beveled end facing back towards the bumper. Don't know if such a piece exists but will start scouting it out. We should tell Bak to make it and send them for free!
#310
TOTM Sept. '18
Thread Starter
iTrader: (1)
Mike, saw your post about plastidip for the X4 bed cover and had an idea. Didn't want to clutter that thread but here's my idea to cover the crummy looking ends. Get a thin rubber strip, silicone it to the tailgate. Flat end backing up to the x4 to hide the edge, curved beveled end facing back towards the bumper. Don't know if such a piece exists but will start scouting it out. We should tell Bak to make it and send them for free!
I didn't have the issue you did with all the aluminum shavings, mine was pretty clean. Probably someone new on the assembly line not trained correctly or just didn't care. I work in manufacturing and it seems like you have to train lower skilled folks how to tie their shoes, they have no common sense.
Mike
Last edited by OCMike; 06-16-2018 at 12:02 AM.