xX-MuricanMade-Xx

Awesome day to get my grille painted...

rotor7911

Are you going with White on the PTM grille?

xX-MuricanMade-Xx

Yeah, oxford white. Also took the emblems apart last night and having them done white and gloss black. Hopefully, pick everything up tomorrow and start putting it back together.

andrewdod

I recommend that you look into AVS products over weathertech. I'm having very good luck with them on my truck.

xX-MuricanMade-Xx

PTM grille and badges.

rotor7911

I saw on Kenmore x 4's,thread that you were ordering some Oxford White vinyl wrap. How did that color match turn out?
Thanks

xX-MuricanMade-Xx

terrible, that's actually why I never went back and recommended it. It's not nearly the same white. It was VVIVID brand gloss white. They said it would be "close" but I didn't agree at all. The vinyl is good quality, nice and sturdy and It might be ok to do some interior parts that aren't in close proximity to painted surfaces but as far as exterior stuff it wasn't even worth trying. I didn't even take any pictures because it was just too obvious of a difference.

xX-MuricanMade-Xx

I'm having the Fox/Roush 2.0 coilovers and shocks put on tomorrow. If anyone sees this post in the next 9 hours and has any input on installing the rears body up or down, or anything else about that set Let me know.

I also picked up a Roush CAI. I had, literally, no intention of actually installing one but I came across one that was cheap enough I figured, why not. It was missing one part and I called Roush to order it and they said they'd just send me one, no charge but it'll be a few days. I'll update once I get that worked out.

andrewdod

I put the 2.0s on my 2013. I did it on the ground. It took me about 6 hours. But truthfully it would have taken a lot less time if my impact gun was charged fully.

xX-MuricanMade-Xx

I didn't get too scientific about measuring height difference but parked in this general location this morning and this afternoon and the front is sitting nearly 3 inches higher. Since this setup is supposed to be closer to 2 inches, I am assuming it needs a bit if time to settle.