Frankentruck and other oddities from Firerunner's World
#581
Senior Member
iTrader: (1)
Don't completely give up hope on your button yet...I'm on the prowl for another (CHEAP) XL / XLT FCIM that I can experiment with to see if I can make the temp **** work in the tight confines of the new bezel. If I'm successful, I gladly put that button in the mail with your name all over it
The following users liked this post:
Firerunner (04-20-2018)
#582
Tommy
Thread Starter
iTrader: (3)
Join Date: Nov 2012
Location: Greenville, North Carolina
Posts: 6,022
Received 4,265 Likes
on
2,183 Posts
#584
Tommy
Thread Starter
iTrader: (3)
Join Date: Nov 2012
Location: Greenville, North Carolina
Posts: 6,022
Received 4,265 Likes
on
2,183 Posts
Slow to get started, but I did wire the camera switch into the trucks main harness & hook up the new FCIM...
I did tape the wires back up with Tesa tape...didn't take photos though
I'm digging the LED rings around the control *****
I did tape the wires back up with Tesa tape...didn't take photos though
I'm digging the LED rings around the control *****
#586
Tommy
Thread Starter
iTrader: (3)
Join Date: Nov 2012
Location: Greenville, North Carolina
Posts: 6,022
Received 4,265 Likes
on
2,183 Posts
No, when you press the hard buttons the display comes on also but the seat itself still doesn't - same with pressing the screen...
#589
Tommy
Thread Starter
iTrader: (3)
Join Date: Nov 2012
Location: Greenville, North Carolina
Posts: 6,022
Received 4,265 Likes
on
2,183 Posts
I haven't completely decided what I'm going to do with the rear either.... But if I decide to paint it, I'll probably buy their rear covers for that job too!
#590
TOTM Sept. '18
iTrader: (1)
Keep in mind on a regular F150 the area in front of the rear bumper on the bedside is considerably larger than on a Raptor because the rear of the bed has more taper to achieve a sharper departure angle. So a Raptor bumper looks a little funny on regular F150. I considered too but could not get past that.
Mike
The following users liked this post:
redbroncokid (04-24-2018)