2017 Platinum, Magnetic SCREW
#12
Senior Member
#13
#15
I would love it if the front wasn't higher than the rear.
The following users liked this post:
UncleG (01-20-2018)
#19
The evolution of the rig continues.
Added today a set of 30W Cree LED lights from Amazon. .
I drilled into the frame using a Cobalt drill bit. You'll need a harder bit since the frame is hardened steel. I used steel tapping screws (not included with the kit) to mount them to the frame.
There are several posts that show you can get power from the center pin on the 7 connector for the trailer. I am using that same pin. Splice and go. No error codes, no faults, no trailer detected.
Day View
Night View from the console
All in all, the install took about 20-25 minutes including drilling and splicing.
Added today a set of 30W Cree LED lights from Amazon. .
I drilled into the frame using a Cobalt drill bit. You'll need a harder bit since the frame is hardened steel. I used steel tapping screws (not included with the kit) to mount them to the frame.
There are several posts that show you can get power from the center pin on the 7 connector for the trailer. I am using that same pin. Splice and go. No error codes, no faults, no trailer detected.
Day View
Night View from the console
All in all, the install took about 20-25 minutes including drilling and splicing.
The following users liked this post:
UncleG (02-27-2018)
#20
Purchased the LED running board lights from F150LEDS. Was pretty impressed on how much light they actually put out. I was pretty skeptical about how a lot of these images appear on a lot of vendor web sites. Anyhow, install took all of about 30 minutes as per their video. Sorry for the crappy cell phone pics. NONE of these pics were edited.
Side shot in daylight parking garage.
Side shot in night time parking garage.
Front view, night time.
Side view, night time.
Side shot in daylight parking garage.
Side shot in night time parking garage.
Front view, night time.
Side view, night time.
The following users liked this post:
UncleG (03-06-2018)