08 DD 4x4 : Cause stock isn't okay
#12
Get Real
Thread Starter
UPDATE:
-Pulled that Thrush. Replaced it with the MagnaFlow XL 3 Chamber and dumped both pipes. Damm it feels and sounds great.
-Also running 33" Nitto Grappler AT's.
Sorry. I forgot I had a biuld thread. Pic coming.
-Pulled that Thrush. Replaced it with the MagnaFlow XL 3 Chamber and dumped both pipes. Damm it feels and sounds great.
-Also running 33" Nitto Grappler AT's.
Sorry. I forgot I had a biuld thread. Pic coming.
#13
Get Real
Thread Starter
Latest pic. Installing body lift on top of 2" level next month. *Not my offroad truck so BL is fine. Actually, I want to use my 15Dy to pull my 98 Ranger SASd 5.0.
#15
Get Real
Thread Starter
If I do the other scheme, I'm probably going to commit to paint. Plasti just isnt ideal for design work and I did this with the leftover can I had and too much time in the particular day.
#16
Get Real
Thread Starter
Wow. I have NOT been on here in a while. Time for a bump. Plus, I have a pile of parts I'm putting on the truck in 2 weeks.
fender flares
4" RC lift
20" wheels
35" ATs
And just through the Maganflow catback exhaust on.
Spacers ruin everuevery so I'm doing it right this time. Will update pics in 2 weeks.
Here's current status. Currently: 3" body lift, 2" spacers, 35s, navigation in dash, Magnaflow with dual dumped.
fender flares
4" RC lift
20" wheels
35" ATs
And just through the Maganflow catback exhaust on.
Spacers ruin everuevery so I'm doing it right this time. Will update pics in 2 weeks.
Here's current status. Currently: 3" body lift, 2" spacers, 35s, navigation in dash, Magnaflow with dual dumped.
Last edited by Kingoverace; 01-09-2019 at 07:54 PM.
#17
Get Real
Thread Starter
Spacers out. Whole front end was out in 2.5 hours. Putting in new upper and lower control arms before putting the lift in. Only need to drop the axle and can put everything back together. I think I estimated about 10 hours to put the kit in. So happy I'm this far along in a short time.
Should have a pic by Sunday.
Should have a pic by Sunday.
#20
Get Real
Thread Starter
Sorry. I’ve been lost in the grown up world and haven’t done anything with truck thread. Lately I’ve switched to 10”x20s wheels with 35s and am currently tire shopping again. I’ve since added a RC 4” lift on top of the 3” Body as well as flares. Im getting a the Raptor style grill tomorrow and also getting a new exhaust tomorrow. Catback duals. Flow master American Thunder. I’m not a Flowmaster guy. I’m magnaflow for that deep growl. But I’ve had tailpipe issues and finally am investing in a stainless steel setup. Just couldn’t find much for a Screw 6.5. My thoughts are have a good set of tails and I can always swap in a Magnaflow muffler later. What do you think of the Flowmaster setup on the 4.6? I’m not one for the loudest setup like most people.
The following users liked this post:
ManMountainDean (12-05-2020)