5.0 Quarter mile times and mods!
09-25-2014, 08:27 AM
#591
I dont see where its required.
I only see ET comparisons on "the list"
Engine wise,
compare averages & not peak.
Air wise,
higher altitudes is less dense,
lower altitudes is more dense,
High humidity is less dense
High humidity allows the use of more timing.
High humidity reduces drag.
Everybody (by your conclusion)
but you, accounting by your statement below.
.
I only see ET comparisons on "the list"
compare averages & not peak.
Air wise,
higher altitudes is less dense,
lower altitudes is more dense,
High humidity is less dense
High humidity allows the use of more timing.
High humidity reduces drag.
but you, accounting by your statement below.
.
Last edited by Fordjunkync; 09-25-2014 at 08:31 AM.
09-25-2014, 09:03 AM
#592
I dont see where its required.
I only see ET comparisons on "the list"
Engine wise,
compare averages & not peak.
Air wise,
higher altitudes is less dense,
lower altitudes is more dense,
High humidity is less dense
High humidity allows the use of more timing.
High humidity reduces drag.
Everybody (by your conclusion)
but you, accounting by your statement below.
.
I only see ET comparisons on "the list"
Engine wise,
compare averages & not peak.
Air wise,
higher altitudes is less dense,
lower altitudes is more dense,
High humidity is less dense
High humidity allows the use of more timing.
High humidity reduces drag.
Everybody (by your conclusion)
but you, accounting by your statement below.
.
09-25-2014, 09:20 AM
#593
09-25-2014, 09:32 AM
#594
Meaner than Ymeski
Thread Starter
Stop running your moufs and start running your trucks. 
The following users liked this post:
HawaiiKid (09-25-2014)
09-25-2014, 10:20 AM
#597
Just like dyno numbers, track times can also vary greatly by density altitude...I make power but most of the time the density altitude here is 5,000FT and up. My 13.2 for example was at 5,950FT DA, I'm sure it would have been a much better time at sea level...
09-26-2014, 07:48 AM
#598
when did this thread turn into a bickering match? I was under the impression this thread was for posting up 1/4 mile times for 5.0 trucks.
I dont care who's truck is faster than who's, or why. I am impressed by each and every one because we are talking about 2.5-3 ton trucks that are turning times that are close to what some of the most powerful muscle cars produced used to run.
relax guys, stock bashin each other nad lets all enjoy our trucks. That is why we're all on here, right? because we love our trucks?
I dont care who's truck is faster than who's, or why. I am impressed by each and every one because we are talking about 2.5-3 ton trucks that are turning times that are close to what some of the most powerful muscle cars produced used to run.
relax guys, stock bashin each other nad lets all enjoy our trucks. That is why we're all on here, right? because we love our trucks?
The following users liked this post:
bobkyle2 (10-05-2014)
09-26-2014, 07:37 PM
#599
when did this thread turn into a bickering match? I was under the impression this thread was for posting up 1/4 mile times for 5.0 trucks.
I dont care who's truck is faster than who's, or why. I am impressed by each and every one because we are talking about 2.5-3 ton trucks that are turning times that are close to what some of the most powerful muscle cars produced used to run.
relax guys, stock bashin each other nad lets all enjoy our trucks. That is why we're all on here, right? because we love our trucks?
I dont care who's truck is faster than who's, or why. I am impressed by each and every one because we are talking about 2.5-3 ton trucks that are turning times that are close to what some of the most powerful muscle cars produced used to run.
relax guys, stock bashin each other nad lets all enjoy our trucks. That is why we're all on here, right? because we love our trucks?
Again, I agree! That's old news, moving on.
09-26-2014, 09:50 PM
#600
Senior Member
when did this thread turn into a bickering match? I was under the impression this thread was for posting up 1/4 mile times for 5.0 trucks.
I dont care who's truck is faster than who's, or why. I am impressed by each and every one because we are talking about 2.5-3 ton trucks that are turning times that are close to what some of the most powerful muscle cars produced used to run.
relax guys, stock bashin each other nad lets all enjoy our trucks. That is why we're all on here, right? because we love our trucks?
I dont care who's truck is faster than who's, or why. I am impressed by each and every one because we are talking about 2.5-3 ton trucks that are turning times that are close to what some of the most powerful muscle cars produced used to run.
relax guys, stock bashin each other nad lets all enjoy our trucks. That is why we're all on here, right? because we love our trucks?