Which wire to splice to make rocker switch light?
#1
Junior Member
Thread Starter
Join Date: Dec 2018
Location: DE
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Which wire to splice to make rocker switch light?
Just installed a LED light bar and wired the harness stight to the battery well after wiring the switch it stays on I want to see how or what tire I should hook up to so the rocker switch works off of the ignition switch any help would be great
#4
Allergic to Asphalt!
You need to use a relay so the LED light bar draws power directly from the battery, but is power on by a switched light source, like your high beams if you want the light to come on only with your high beams, or a parking light if you want it on when the car is on.
#5
Junior Member
Thread Starter
Join Date: Dec 2018
Location: DE
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
I have 5 pin rocker switch after looking at a couple things online my question is if I wire the rocker switch and wanted to run off ACC I will have to tap a wire off of ACC power source I'm connected into prong 6 of the rocker switch with the rocker switch I received a jumper which connects 2 + 6 so would I not connect the jumper wire into 6 and run a ACC into 6 prong rocker switch and this will allow my rocker switch to turn on and off off of ACC power
Last edited by Rlegates1; 12-10-2018 at 11:51 PM.