Chipfoose

Hey i have a 08 fx2 chip foose f150
Id like to fully drop it eventually
It came from factory with 1.5" or 1" lower in the front
Im taking the 1" block out of the rear under the leafs
Ive been looking at lowering kits and have no idea
If they have everything ill need
Some kits are a few 100 some are over 1000
Id like peoples imput and reveiws on
Cheapest ways and the proper ways to lower the truck
I know everything about lifting trucks
But not alot on lowering
Id like it to sit extremely low
As i never tow anything or use the bed for anything
I use the truck as a summer cruiser and more of a show truck then anything

I dont know if it would make more sense to bag it
Or to just have a non bagged drop
I dont want to spend a ton of money either
But i dont want to put anything on the trucj
Thats cheap quality
Whats the lowest i can take the truck without having
To spend crazy amounts of money

Any suggestions on good kits to buy?
Id like it as low as possible but still needs
To be able to go over speed bumps.... Slowly maybe on an angle
Haha
Thanks for any help!

MileHighFX2

I own a 2010 FX2 lowered 3.5/5.5 with all belltech products. Belltech has always been a good product to me. I also have a yukon with a 2/4 using all belltech as well and never had any problems. There is also DJM but I have never used anything from them so I can't say anything good or bad about it. But, You can't go wrong with belltech and its not gonna cost you an arm or leg