Edge Evo HT (W1) there was an error uploading EEprom file.
08-10-2012, 11:39 PM
#1
Edge Evo HT (W1) there was an error uploading EEprom file.
Truck is a 2008 ford F150 Lariat 5.4L V8 gas.
<--- stupid here didn't update before plugging it into my obdII. Guessing that is what is causing my error? I set my truck back to stock settings so it isn't vin locked. Is there a way to reset the EVO HT completely so I can try to update first and go from there?
Only other mod done to the Truck is K&N intake system. But I am scared that because I did not update it that I will lean the truck out after adding the intake. I got them both on the same night and jumped into it head first without reading anything like an over anxious kid on christmas morning....
<--- stupid here didn't update before plugging it into my obdII. Guessing that is what is causing my error? I set my truck back to stock settings so it isn't vin locked. Is there a way to reset the EVO HT completely so I can try to update first and go from there?
Only other mod done to the Truck is K&N intake system. But I am scared that because I did not update it that I will lean the truck out after adding the intake. I got them both on the same night and jumped into it head first without reading anything like an over anxious kid on christmas morning....
Last edited by jamesschmidt82; 08-10-2012 at 11:51 PM.
08-13-2012, 08:06 PM
#4
Your Mod Superstore!
James, you might want to try calling Edge Support or going online to see if they can help you with software related issues.
The following users liked this post:
jamesschmidt82 (08-18-2012)
08-18-2012, 06:23 PM
#5
ya It was hard to get ahold of them because of time zone difference and my hours. but I managed to and they just had me go to superchips and use that software to update. Said it wasn't anything I did, just a problem they have run into a few times with the evo. Thanks though!