The cab stake hole is covered and has no releif pop-out. I'd like to install my CB antenna but I'm not sure the best way to mount it. I was thinking just a stake hole mount, but was worried that it might stick up a bit and not allow the plastic piece to lay flat - although it appears that it has a space between the bed and the plastic...not sure, and before I go tearing this appart, I thought it best ask!

I'm learning patience!

2012 XLT Screw 5.0

 

http://bellsouthpwp.net/b/r/breedlove1/

http://www.geotool.com/antmount.htm

Hope this helps.

 

How does one tighten the bolt of the Geotool mount to the bottom of the stake pocket? Can one get access to use a wrench through the tail light assembly opening?

 

I took the tail light off to see what access it allows. One should easily be able to tighten the bolt with a ratchet wrench after removing the tail light assembly.