RDFTS's RR SE - Pics!
#131
It's an ID10T error sir!
iTrader: (1)
Farewell. Don't come here as often as I once did and decided not to renew my supporting membership. Might swing by once in a while when I am on a PC. Latest pics. Got a black skid plate and will use it most of the time. Will use the other one when off-road since its already dented.
#132
Couple of my latest upgrades. Rogue Racing Heim adjustable UCA's and replacement Steering Knuckles with Outlaw gussets. Next upgrade will be the tie-rods but that will most likely be several months from now.
Last edited by RDFTS; 11-17-2014 at 11:34 PM.
#134
Knuckles aren't anything noticeable. I got them because I bent my passenger side. I think it happened when I would be coming around a corner at speed and nailing a few harden mud ruts that I got caught in due to the terrain. So until I do something like that again, I really won't know. With it being slightly bent, I couldn't get an alignment done correctly, my camber was too far negative even though the lowers were pushed in as far as they could go. So I was either replacing the knuckles with stock again and possibly dealing with this again or replace them with something beefier. The aftermarket knuckles at $2k+ was a tad too rich for my mod budget (don't really have budget, I am out of control somewhat). I got these set for $325 shipped from someone taking them off since they are going long travel with their suspension. I am sure if I try hard enough, I can bend these too but now I will pay more attention knowing what could happen.
#135
It's an ID10T error sir!
iTrader: (1)
Knuckles aren't anything noticeable. I got them because I bent my passenger side. I think it happened when I would be coming around a corner at speed and nailing a few harden mud ruts that I got caught in due to the terrain. So until I do something like that again, I really won't know. With it being slightly bent, I couldn't get an alignment done correctly, my camber was too far negative even though the lowers were pushed in as far as they could go. So I was either replacing the knuckles with stock again and possibly dealing with this again or replace them with something beefier. The aftermarket knuckles at $2k+ was a tad too rich for my mod budget (don't really have budget, I am out of control somewhat). I got these set for $325 shipped from someone taking them off since they are going long travel with their suspension. I am sure if I try hard enough, I can bend these too but now I will pay more attention knowing what could happen.