pinion angle adjustment for 2 pc driveshafts
#1
Member
Thread Starter
pinion angle adjustment for 2 pc driveshafts
so i see bits and pieces in different threads and figured i'd start a thread just for this topic. where can we find a calculator to punch in the angles and figure out the adjustment needed? my rear end is currently sitting at 3.5* and driveshaft is at 1*. i'm trying to figure out how to get it at -2 as a final. is a carrier shim easier than a pinion shim at the rear end?
#2
2012 FX4 ECOBooooost
iTrader: (1)
Good read:
http://65.170.161.218/~spicerpa/sites/default/files/pdf/driveshaft_installation.pdf
front shaft set same as trans, pinion opposite trans (page 14)
http://65.170.161.218/~spicerpa/sites/default/files/pdf/driveshaft_installation.pdf
front shaft set same as trans, pinion opposite trans (page 14)
#4
Member
Thread Starter
Good read:
http://65.170.161.218/~spicerpa/sites/default/files/pdf/driveshaft_installation.pdf
front shaft set same as trans, pinion opposite trans (page 14)
http://65.170.161.218/~spicerpa/sites/default/files/pdf/driveshaft_installation.pdf
front shaft set same as trans, pinion opposite trans (page 14)
exactly what i was looking for! thanks