Belltech 0-3/5.5 problem
#22
Senior Member
installed my wheel spacer today. it actually didn't fit.... I mean it wouldn't slide over the studs. It was probably 1/16" off at each stud. I broke out the die grinder and clearance the holes just a hair, took about 30 seconds, and then it slid right on.
Now the rear end at least looks centered from side to side. The inside bore of the spacer fit right around the previously fitted hubcentric spacer so I don't think there will be any balance issues.
Now the rear end at least looks centered from side to side. The inside bore of the spacer fit right around the previously fitted hubcentric spacer so I don't think there will be any balance issues.
#23
Senior Member
I haven't noticed it on mine. I'll have to check later.
The following users liked this post:
Bronson Sherrill (02-06-2018)