DJM to Belltech.......
#1
Lift,lower,stock,wrecked
Thread Starter
DJM or Belltech/Arms or struts
Who has lowered with the DJM LCA's and then changed to Belltech struts, or the other way around? I've heard you get steering shake with the arms. Then I've read about the BT struts breaking or not lowering a full 3". My plan was to use the LCA's this time instead of Crown's coils, but I'm not 100% sure that I want the LCA's or the struts.
I'd hate to drop that money on the arms and then hate them. For the record I've ran the BT struts on a Chevy set at 2" and had no problems.
I'd hate to drop that money on the arms and then hate them. For the record I've ran the BT struts on a Chevy set at 2" and had no problems.
Last edited by texasbred; 04-28-2017 at 09:58 AM.
#2
Senior Member
I put belltech struts on the from on my '13. Had them on for 40,000miles with no issue. I only pulled enough spacers for 2" drop and it dropped the front 2 1/4". When I lower my '16 Ill be going with belltech again.
The following users liked this post:
2016BoostedGreyGoose (04-28-2017)
#4
Lift,lower,stock,wrecked
Thread Starter
#6
Senior Member
here's a write up of my experience with belltech struts and lowering control arms. Kinda long, but might be a worthwhile read, as it addresses your thoughts
https://www.f150forum.com/f66/lets-s...5/#post5114100
https://www.f150forum.com/f66/lets-s...5/#post5114100
#7
Lift,lower,stock,wrecked
Thread Starter
Thanks, I think I'm pretty settled on the DJM arms and then one day when money allows run the Belltech 09-13 adjustable coilovers. I plan to use the Crown flip kit I have without the add-a-leaf and add 1 inch shackles. Eventually I may take it down to a 4/6 but don't want to be dragging traction bars all over the place.
Trending Topics
#8
Senior Member
Thanks, I think I'm pretty settled on the DJM arms and then one day when money allows run the Belltech 09-13 adjustable coilovers. I plan to use the Crown flip kit I have without the add-a-leaf and add 1 inch shackles. Eventually I may take it down to a 4/6 but don't want to be dragging traction bars all over the place.